philfrost432 Posted May 7, 2014 Share Posted May 7, 2014 Need to remove my shafts out of my oem LSD gearbox how do I do this they will not just pull out like normal shafts thanks in advance Quote Link to post Share on other sites
Beastmode panda Posted May 7, 2014 Share Posted May 7, 2014 Need to remove my shafts out of my oem LSD gearbox how do I do this they will not just pull out like normal shafts thanks in advance Should do, wiggle it out with a thin flat head evenly. Quote Link to post Share on other sites
5e colin Posted May 7, 2014 Share Posted May 7, 2014 they come out the same way lad !!!!! there is a lip on the cup put a bar on it and hit the bar with a hammer it will pop out Quote Link to post Share on other sites
philfrost432 Posted May 7, 2014 Author Share Posted May 7, 2014 Okay cheers lads thanks for the info will give it a go when I am next free :-) Quote Link to post Share on other sites
philfrost432 Posted May 9, 2014 Author Share Posted May 9, 2014 Still carn't get them too budge out, seem like they don't want too move any ideas need too fit my new gaiters cheers Quote Link to post Share on other sites
Kyle_R Posted May 9, 2014 Share Posted May 9, 2014 It's easier to split the cups on the gearbox side remove the retaining ring of the inner boots pull boot back off the cup and then the shaft will make some lovely squelchy noises and slide right out. It's the method I always use Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.