lukebrown4321 Posted January 23, 2015 Share Posted January 23, 2015 i have fitted the corolla 4-2-1 mani to my starlet and the lambda sensor hole is in a different place so the lambda sensor no longer reaches just wondering if it will pass an mot without the lambda sensor or will i need to extend the wires thanks Quote Link to post Share on other sites
Chops Posted January 23, 2015 Share Posted January 23, 2015 it might start to run like a bag of shit without the lambda sensor bud, id look into getting some sort of extention for it! Quote Link to post Share on other sites
mikey4410 Posted January 23, 2015 Share Posted January 23, 2015 extended the wire.its really easy and its a mono signal so it will be bang on with a stock piece of copper wire DONT run without lambda mate !!!!! Quote Link to post Share on other sites
onnaj1000 Posted January 23, 2015 Share Posted January 23, 2015 Is that mani a direct fit? And which mani did you use?Thanks! Quote Link to post Share on other sites
lukebrown4321 Posted January 23, 2015 Author Share Posted January 23, 2015 Its a cast iron 4-2-1 manifold thats in 2 sections the 4-2 section has a lambda sensor hole then there is a separate 2-1 section think its from a toyota sera not a corolla extended the wire.its really easy and its a mono signal so it will be bang on with a stock piece of copper wireDONT run without lambda mate !!!!!Thanks will have a proper look at it tomorrow Quote Link to post Share on other sites
FMuscle Posted January 24, 2015 Share Posted January 24, 2015 You might be able to reroute the wires, instead of extending them, check if you can pull the wires out of the loom to bring them closer to the hole... Not sure on the starlet, but my previous car could be rerouted like that, and I did it for my temp sensor on the 5E... Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.