Jump to content

Idle control valve wires


Recommended Posts

Hello gang just need alittle advice please,

Was under the bonnet today changing air filter and as you do while your there checking hoses plugs and sensors, I put my hand on the icv sensor only for one of the wires to come out (due to age must be being brittle as redone other sensor wires that pop out the hole). Obviously I will get it redone ASAP and connect the wire back up, but my question is will the car be ok to run like that for the next few days, have been out in it since and car just runs normal like it should not even high idle, thanks pat

Link to post
Share on other sites

Hey Ollie yeah heard people doing this, what did you do with the sensor? (Just tuck it away) plus the hole in the side of the inlet? And the pipe bit what goes into the bottom of the icv?

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...