matthew ep91 Posted July 28, 2015 Share Posted July 28, 2015 Where should i start checking ? Quote Link to post Share on other sites
5T4R7ET N/A Posted July 28, 2015 Share Posted July 28, 2015 (edited) Start by checking the bulb has not gone in the dials console.Then check OIL pressure sensor wiring.Normally light stays on when its messed up but you never know Edited July 29, 2015 by 5T4R7ET N/A Quote Link to post Share on other sites
daniel_g Posted July 28, 2015 Share Posted July 28, 2015 Check the wire is plugged into the switch, its located at the lower front of the block, under the slave cylinder near where the gearbox bolts to. Its a single yellow wire which runs up to the thermostat housing and into the rest of the loom. Quote Link to post Share on other sites
matthew ep91 Posted July 29, 2015 Author Share Posted July 29, 2015 Ok ive replaced the bulb with no joy.the wire is plugged in at the switch . What should i try next ? Quote Link to post Share on other sites
matthew ep91 Posted July 29, 2015 Author Share Posted July 29, 2015 Where should i start checking for the fuel pressure sensor wiring ? Quote Link to post Share on other sites
daniel_g Posted July 29, 2015 Share Posted July 29, 2015 Check the wire isnt broken from the ecu to the sensor. Quote Link to post Share on other sites
matthew ep91 Posted July 29, 2015 Author Share Posted July 29, 2015 I took the wire off and earthed it to the block and the light came on. So im just gna try a new oil pressure sensor Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.