bajansuperman Posted August 21, 2015 Share Posted August 21, 2015 Hi guys have a celica injector resistor pack and would like some help installing it, so far I know the 4 black wires go to the right side on the injector and the white to all on the left then I'm lost from there Quote Link to post Share on other sites
bajansuperman Posted August 21, 2015 Author Share Posted August 21, 2015 Quote Link to post Share on other sites
Stu Posted August 24, 2015 Share Posted August 24, 2015 Do those two packs share any wiring? It looks like two different packs to me Anyway, normally there will be a single 12v feed wire in that's larger diameter and then two or four output wires. So I'd say white is 12v feed and black is 12v to the injectors. What ecu are you using and what impedance injectors are you want to use? You will need to take that into account when working out if those ballasts are the right size. Quote Link to post Share on other sites
bajansuperman Posted August 24, 2015 Author Share Posted August 24, 2015 I will be running evo 510 injectors and I will be running a megasqurit v3 Quote Link to post Share on other sites
Stu Posted August 24, 2015 Share Posted August 24, 2015 Ah yeah low impedance units. Ideally you'd want that resistor pack to be at least 4.5-5ohms per channel Quote Link to post Share on other sites
bajansuperman Posted August 25, 2015 Author Share Posted August 25, 2015 My question is where do I run the white wire Quote Link to post Share on other sites
Stu Posted August 25, 2015 Share Posted August 25, 2015 (edited) I said that above, its the 12v feed to the ballasts. When using ballasts the wiring goes 12v feed > (ballasts white wire) > ballasts > (ballasts black wire) > injectors 12v side of injectors plug. Other side of injectors plug runs direct to the ecu injector drives. Edited August 25, 2015 by Stu Quote Link to post Share on other sites
bajansuperman Posted August 26, 2015 Author Share Posted August 26, 2015 OK thank you for the info Quote Link to post Share on other sites
Stu Posted August 26, 2015 Share Posted August 26, 2015 No problem. Be sure to check the ballasts resistance before using them to check they're adequate Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.