EP70-PT Posted January 8, 2016 Share Posted January 8, 2016 So, I'm from France and It's hard to source a full Glanza bootlid so I'm installing the number plate surround and spoiler myself. Can someone make me a template for the reg holder (Hole placements) so I can drill and cut the NA boot without screwing up? Starlet parts are freaking impossible to get here so if I do it wrong, I won't get another chance... x) Quote Link to post Share on other sites
EP70-PT Posted January 8, 2016 Author Share Posted January 8, 2016 Make a template then scan it Of course, no post needed Quote Link to post Share on other sites
Ollieh17 Posted January 9, 2016 Share Posted January 9, 2016 Can you just but the reg holder against the boot lid and mark out the holes from that? Quote Link to post Share on other sites
EP70-PT Posted January 9, 2016 Author Share Posted January 9, 2016 No because there's clips that have to go in a hole that I have to drill and I can't Just pust a marker through.. Same for the reverse lights x) Quote Link to post Share on other sites
Whitenoize Posted January 9, 2016 Share Posted January 9, 2016 I'm sure you just measured it up a few times and mark it out and double check before you start cutting anything it would be fine.. loads of people have done it Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.