Ep91 wiring diagrams

[Craigtrials95]

Any complete wiring diagrams about for a glanza v ep91? Cheers

[starletezy]

What diagram you after ?

[Craigtrials95]

ignition circuit complete. ive lost engine managment light on ignition and car wont start, managed to get fault code 14 which is no signal to ignition/igniter

[starletezy]

Try this lots of useful info and also has complete ignition circuit diagram

ignition circuit complete. ive lost engine managment light on ignition and car wont start, managed to get fault code 14 which is no signal to ignition/igniter

http://glanzamini.blogspot.co.uk/2011/11/wiring-loom.html

http://glanzamini.blogspot.co.uk/2011/11/wiring-loom.html

[Craigtrials95]

Cheers man, I'll have a look through that hope it gets somewhere

[starletezy]

Cheers man, I'll have a look through that hope it gets somewhere

No probs let me know how you get on

[jellybaby]

Check the plug

On your blower

Motor if that's disconnected u won't get a eml

[Craigtrials95]

Got it sorted and running today, ripped out my alarm and wired the car up without it and it sorted the problem. But now it blows fuse am2 I think it is quite often

[Craigtrials95]

Got the car running fine today, turned it off after letting it run up to temperature then tried to start it again a few minutes later and there is nothing at all, no lights on dash, no noise or anything. help please

[starletezy]

Have you tried checking every single fuse and relay on the car?

[starletezy]

Just remembered someone couple months back had the same issue no cluster lights no ignition noises and the car wouldn't start ether it turned out to be the main relay that was blown it might be a dodgy relay

[Craigtrials95]

Cheers starletezy I'll have a look over it all this weekend and I'll reply with the results.

[Craigtrials95]

got a faulty 30amp igf relay under dash tested it using an 12v supply and for continuity. got one ordered from toyota hopefully solves the problem

[starletezy]

have you checked all relays ?

[Craigtrials95]

That's her running again after replacing efi relay, and now another problem too look at tomorrow. My windows won't work and the wipers go up but not back down haha