mccartney11

Yes get onto Richard Clarke on facebook

I don't see how it runs ok while it's a bit warmed up ?

Bump

First time dealing with turbo Toyota setup , I've converted my ep70 to 5efte, when I start it it cuts out 3-4 time then it'll start and run at 700rpm sounds like it's running on 2 cylinders and won't rev properly, but as it warms up it revs normal, any ideas? Next is it gets hot quite quickly, like after 4-5 mins running the heat off the manifold is severe , making me wonder is something up I've never known them to get this hot, it's also boiling the water in the rad , it's blowing steam out the overflow , both rad pipes are hot , I've checked thermostat and it's opening and closing fine, a

Changed sensor still won't fire first kick, it'll start and run if I spray fuel/easy start into throttle body tho and it'll run fine, although when it's cold if I press accelerator it dies down and nearly cuts out unless I tap accelerator lightly to bulld up revs any ideas?

Can u get a pic for me please ?

Glanza , it's the actual loom plug I need now not the sensor, unless someone can tell me what sensor I can use on this plug

Looking for the plug for the green sensor if anyone has a spare

Yes

Any available?

Thanks:) They're mk1 mr2 sideskirts cut and shaped to fit, got the exhaust system done now just have to get front mount piping to take it out for a rip

Coolant temp sensor plug is broken so that could be my issue I'll pick one up and try it then go from there so

Hi, I did a 5efte conversion on my ep70 and I can't seem to get the engine to fire first time without easy start? Once it starts it'll run, but just won't kick without it....is this an injector issue?

Don't cut the floor of a genuine ep71!!!! Tanknos easy to drop , one bolt on leg for filler pipe, two under for the straps and just pop off hoses and wires , in and out in an hour on a jack and stands anyway

I bought two calipers and hubs for my starlet, both hubs from an early spec glanza got both calipers off two different cars in sure of whether one was early one was late Driver side caliper bolted up fine, pass side one won't line up with the holes at all

There's a thread on here

That looks tidy lad be worth looking into that , was piping handy done too?

Bumo

Looking a small front mount intercooler , must be less than 70cm from edge to edge of the flanges

One is fine

Bump

Anyone know what wires to use on a glanza tank for the fuel gauge? I've done a boxy conversion and fitting a glanza tank I know top two are for the pump and bottom left and right two go to the sender but can anyone tell me what the wires for the fuel gauge are ? Which is positive or negative etc ?

I'm using one of Richards looms in my ep70, works a treat:)

http://id-workz.co.uk/Makes/toyota/starlet/starlet-turbo-ep82-and-ep91/cooling-1/id-workz-half-size-radiator-fitting-kit-ep91