00joeindastarb0

Like the look of that

Is it possible to just replace 2nd and 3rd or 3rd and 4th as they seem to offer this option for the Honda and Ford boxes?

As title states I'm looking for a JAM fcd specifically as I want a clamp style device.

Many thanks

Joe

Are you running stock boost at the moment

I have used miller running in oil about £20 for 5l

I hope that's the case, it seems every other Jap car has.

Sorry mate I have them in an envelope by the front door just need to go by a post office

https://www.ebay.co.uk/itm/162322433597

Would be wicked with a 4efte.

There right I think will confirm tomorrow pm me your address

I think I have some do we know the length to be sure. Send me over your address mate.

I thought idworkz made reps but it seems they don't, looks like Japan is your only option.

There was one on here the other week I'm sure of it

You do have to notch the block in most cases with the i beam design of rod like the Scat or Maxspeeding, however you can get Pauter rods which are very good quality and light which you pay for and they have clearance being a x design.

Check any vacuum lines going to the inlet and throttle body they might be a contributing factor

Been waiting for one of these to come up for ages, there getting really rare with fogs as well. Wrong time unfortunately, good luck with the sale

Whereabouts are you Adam?

If it's taking more than 10 minutes on each valve something isn't right.

It shouldn't take more than a few minutes on each one if the seats and valve faces are decent.

No it's a bit specialist really

You need to check the movement of the valve in the guide, I had to replace my exhaust side.

You should be able to give them a little squeeze one way and then the other with the pliers and then wiggle them out. You'll get it down after a few.

Or they do actually manufacture special pliers specifically for the job.

Seat the valves either way, I lubricated the guide and seal when doing so.

I think this should be significant for the starlets, my mates always going on about the one for his Mx5.

Definately something I would go for.

Looks so cool! Well done man.

Pmd