dwd

They can be switched to soft cut. Did you connect the coil (-) to earth on the body? Cant see a negative on the coilpack on any wiring diagrams

I have no interest in pops and flames. Its a competition car with a newly built engine. Ive been running no rev limiter but that ended with a rod through the block on the last engine so want to safely limit it. Were you using hard or soft cut? I haven't a clue about electronics so am not sure what wire on the dizzy to use since there is no red and blue on it. Maybe I will ask elsewhere.

Thanks for this wisdom.

That's the wires from the rev limiter but I am asking what they connect to on the car.

The instructions say to connect to the coil + and coil - Does anyone know what colours these are on a ep82 4efe?

cool thanks

at 700rpm idle?

Anyone know what the standard timing setting for a 4EFE is?

Im looking for some rad Silicone Hoses for a 4EFE. They seem to be more widely available for the 4EFTE. Does any know if they are the same?

So whats the difference then? is the 5e one hardened?

But I thought the 5efe and 5efhe cranks are different?

Are 4efe and 5efe big ends all different to the 5efhe?

Just sent them a message now. Fingers crossed they have something

I've tried around including Toyota but they don't seem to be available. Does anyone know if they can be got?

Guys, Im building a 5EFHE engine for competition use. Its nothing fancy, just a standard spec rebuild. Its had a reground crank, new bearings, new rings and head work. Im a bit worried about running it in, and bedding in the rings. Ive done some searching and found some info but it all involves a lot of time. I am probably going to be left with only a week or two to bed it in before it needs to be bouncing off the limiter when used at an event. It is a road legal car so it will be possible to clock up some km's, but can anyone advise on the best way to run it in without covering thousands of kilometres?

pm sent

Anyone?

No, I presumed they would be very expensive. Might try though. Anyone else have one? Would consider a full set either

Im looking for one 1 x 5EFHE Con Rod asap. Can collect in Ireland or South East UK. Otherwise will pay postage. Anyone have one?

??

I have a EP82 JDM n/a and want a subtle quite exhaust upgrade. Was thinking of trying a stock GT box. Anyone know if it will fit straight on?

Looking for 5efe ecu. Pm me if you have one.

Looking for a good quality fuel pressure regulator. n/a fuel injection type. Anyone have to?

Cool, Ill try that. Thanks for the advise

Thanks for that. How much could I up the fuel pressure to?