Cattanach Posted November 14, 2016 Share Posted November 14, 2016 Anyone on here who can weld the wastegate shut on my ct12 if I were to send it to them ? Link to post Share on other sites
Starlet__SR Posted November 14, 2016 Share Posted November 14, 2016 Either find someone local or Midland Turbo. Link to post Share on other sites
Ollieh17 Posted November 14, 2016 Share Posted November 14, 2016 I always used to just tack the actuator arm in closed position. Know anyone with a mig or stick welder? Take 2mins Link to post Share on other sites
Cattanach Posted November 14, 2016 Author Share Posted November 14, 2016 Nah don't know anyone who can weld unfortunately!Thought I would try here first haha Link to post Share on other sites
jamesglanza Posted November 14, 2016 Share Posted November 14, 2016 There's no metal fabricators, garages or local welders near you? I'm sure if you gave them a tenner they would weld it for you in there lunch break Link to post Share on other sites
Cattanach Posted November 15, 2016 Author Share Posted November 15, 2016 There is just thought someone on here might want to earn some cash haha Link to post Share on other sites
triple j Posted November 15, 2016 Share Posted November 15, 2016 U could make up a little bracket that bolts to where the actuator was and the other end hooked over the waste gate arm holding it shut. Link to post Share on other sites
adzy Posted November 15, 2016 Share Posted November 15, 2016 U could make up a little bracket that bolts to where the actuator was and the other end hooked over the waste gate arm holding it shut.I made one of these and then used a threaded bar so you could tighten it shut, did a good job Link to post Share on other sites
Recommended Posts