Twin pot clearence

[glanza ep91 23]

Im fitting my twinpot carries and the disk is rubbing on the carrier and on the otherside it fits perfect??

Edited June 4, 2017 by glanza ep91 23

[SpikeyJp_68]

Is the wheel bolted on ?

[glanza ep91 23]

Ya evething is tighen down i thinking could it be a fucked bearing car been off the road for a while

[SpikeyJp_68]

  On 6/4/2017 at 5:08 PM, glanza ep91 23 said:

Ya evething is tighen down i thinking could it be a fucked bearing car been off the road for a while

Did you sand down the stub axle before putting the disk on ?

[glanza ep91 23]

Yup the disk is on flat it the bearing i think because there abit of play in it and i think the wobbel is causing it to rub

[Foggy]

What discs and carriers are you using?

[glanza ep91 23]

The disk and carries are fine because it fit the otherside perfect it just that one side where it rubs hence y i think it could be the bearing

[epcashin]

10mm spacer behind the discs would work would have to get a machine shop to make up soemthing

[gorganl2000]

  On 6/6/2017 at 10:32 AM, glanza ep91 23 said:

The disk and carries are fine because it fit the otherside perfect it just that one side where it rubs hence y i think it could be the beari

based on this, i think something is amiss with the side that is rubbing as well,,,check out the problem side carefully---any hub changes?

if it was the set up, most likely both sides would have an issue

Edited June 6, 2017 by gorganl2000

[ChineseMafia]

  On 6/4/2017 at 3:34 PM, glanza ep91 23 said:

Im fitting my twinpot carries and the disk is rubbing on the carrier and on the otherside it fits perfect??