Allyboy81 Posted July 22, 2017 Share Posted July 22, 2017 Hello, I wa fitting my alarm today and all went well apart from the hazards/indicators. My alarm box gives out a 12v pulse when locked and 2x 12v pulses when unlocked so that's ok. I probed green and black wire out of indicator switch and it was getting an indicator pulse so wired it up and nothing. Pulled out hazard switch and found green and black wire giving same pulse but when wired up still no indicators when fob is pressed. I even probed green/black wire and green yellow wire at o/s kick panel again getting indicator pulse but when wired up nothing! Any hints to what I'm missing? Cheers in advance Quote Link to post Share on other sites
akyakapotter Posted July 22, 2017 Share Posted July 22, 2017 I will have a look tomorrow on my hard drive and tell you the wires i tapped into to make the alarm flash with arming and dissarming i think i still have it, Cheers Nick Quote Link to post Share on other sites
Allyboy81 Posted July 22, 2017 Author Share Posted July 22, 2017 Ok, thank you Quote Link to post Share on other sites
lukEp Posted July 23, 2017 Share Posted July 23, 2017 (edited) Use the wires out the back of the hazard switch thats were mine are. Make sure you connect to output not input. Edited July 23, 2017 by lukEp Quote Link to post Share on other sites
akyakapotter Posted July 23, 2017 Share Posted July 23, 2017 Hi bud i cant find the guide i used but im 90% sure i took that part from the under steering wheel cowling. cheers nick Quote Link to post Share on other sites
Allyboy81 Posted July 23, 2017 Author Share Posted July 23, 2017 I tried under there and also looked at back if hazard switch. I'm definitely doing something wrong I will have another go on Monday. Thanks for the replys people. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.