Glanza-Ben Posted April 22, 2013 Share Posted April 22, 2013 I need a hole type actuator ASAP that will fit the pic below as my hks one is clearly no where near the right one If it makes any odds this is a speed vision 2 hybrid ct9 Link to post Share on other sites
asbo-v Posted April 22, 2013 Share Posted April 22, 2013 Got std one if helps Link to post Share on other sites
Glanza-Ben Posted April 22, 2013 Author Share Posted April 22, 2013 If its a hole type then yes would help a lot I hope lol Link to post Share on other sites
asbo-v Posted April 22, 2013 Share Posted April 22, 2013 its a standard actuator ct9a of a ep91 Link to post Share on other sites
Glanza-Ben Posted April 22, 2013 Author Share Posted April 22, 2013 How much posted think I have sorted this now but would be handy as a back up Link to post Share on other sites
A L 3 X Posted April 23, 2013 Share Posted April 23, 2013 (edited) Drill the pin out of your old actuator if it lines up? Edited April 23, 2013 by A L 3 X Link to post Share on other sites
H_D Posted April 23, 2013 Share Posted April 23, 2013 I had this issue when somone wanted to fit a ct9b to ther ep82 which already had a hole type HKS actuator on the original CT9a. The ct9 b has a hole and the ct9a has a pin. I used a high tensile screw to feed through the hole and put a nut on the end of it. It still works fine after 2 years. Or you can drill the pin out on the actuator arm so it fits onto the pin on the turbo and you should still be able to put the c-clip on it Link to post Share on other sites
Recommended Posts