catch can set up

[sosolid]

how should i set up a catch can. ive got standard boost but some other of the other mods so how would i set up a catch can?

[mattep91starlet]

There is a topic about this in the photo section "post your catch can" as I think there is a certain way to route them so I would be careful and get all the advise you can

[sosolid]

thanks see it but everyone seems to be confused. so i want to get to basics. the pcv release air into the inlet manifold. so what does the breather do? does it suck in air or breath in air?

[RobSR]

Theres loads of ways for them to be plumbed in, but just take out the pcv valve, and run that and the other breather to a vented catch can

[DaddyDutch]

Was wondering this myself, as I'm putting mine in during the week hopefully.

Al.

:-)

[daniel_g]

Theres a pic of 'theminigurus' bay in POTM, i like the look of his catch can setup.

[DaddyDutch]

Theres a pic of 'theminigurus' bay in POTM, i like the look of his catch can setup.

I'll need to check that one out.

Cheers for the heads up.

Al. :-)

[TurboTobz]

Can see this turning into a bitching match

[daniel_g]

Lol ^^ there is an old thread on here from back in the U.K.S.C days all about catch can setups, there was a bit of a riot in there haha.

[TurboTobz]

I remember these lol, good old handbag war

[daniel_g]

Before the sweepy sweepy lol.

[TurboTobz]

Or the control+c control+v if you get my jist

[daniel_g]

I get ya lol.

Anyway, so 'bout those catch cans ay. Wonderful things...