nathan87 Posted November 3, 2013 Share Posted November 3, 2013 HelloI'm going to start building an engine very soon and will be fitting into my sportif.I'm aware of the parts I need etcMy question is:I will be running a standalone ecu will I still need to convert the rest of the loom? Quote Link to post Share on other sites
mikey4410 Posted November 3, 2013 Share Posted November 3, 2013 ideally u still need a knock sensor im sure and a few other bits,but im sure theres no need to convert whole loom if your going standalone....... Quote Link to post Share on other sites
nathan87 Posted November 3, 2013 Author Share Posted November 3, 2013 That was my thoughts but always good to ask.That would have been my next question, what other little sensors would I need to get aswell Quote Link to post Share on other sites
TurboTobz Posted November 3, 2013 Share Posted November 3, 2013 MAP & Knock for sure Quote Link to post Share on other sites
RobSR Posted November 3, 2013 Share Posted November 3, 2013 Yup if your going standalone, map and knock i think should be the only ones you need. Quote Link to post Share on other sites
dangeestarlet Posted November 3, 2013 Share Posted November 3, 2013 Can you use the same loom if you use a piggyback? Quote Link to post Share on other sites
RobSR Posted November 3, 2013 Share Posted November 3, 2013 ^ yea would work. Youd still need to add in a knock sensor and map aswell tho. Quote Link to post Share on other sites
dangeestarlet Posted November 3, 2013 Share Posted November 3, 2013 Ok no worries , cheers Quote Link to post Share on other sites
nathan87 Posted November 3, 2013 Author Share Posted November 3, 2013 Ahh that's good to hear about the piggyback aswell, as i may be able to get hold of one of them cheaper and easierThanks for everyone's help Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.