running speedvision hybrid,difference between 1.0,1.1 & 1.2 bar

[mikey4410]

Hey guys.

got a freshly rebuilt ct9 speedvision hybrid.

I have seen and taken in the starlet leaderboard of top bhp of said turbos etc etc.

I did notice that when it comes to the hybrid ct9s that nobody on the board really ran more than 15 psi

is this because there is nothing else to be had after a bar/14psi despite hybrid ct9s being rated anything up to 1.3bar

anybody got some dyno graphs or threads relating to this and/or have any knowledge of hybrid varients over a bar please??

[mikey4410]

Bump

[JayJ]

I was planning to run 1.2bar with Tongs hybrid, but stock injectors are almost maxed out at 1bar, so that's where we left.

[mikey4410]

Thanks for the comment jayj.

much appreciate ure input :-D

[Gainzy]

Anything over 1 bar is quite a bit of heat, nice and safe at 1 bar

[mikey4410]

Okies gainzy. Will stick with a bar.

so far adjusted the manual boost controller to 0.85

Done a second gear run to redline 4 seperate times and cleared my gizzmo each time to confirm peak boost (use gizmo as boost guage only) and each and every time hits 0.85.my god its so much better already and not even at a bar yet.

[mikey4410]

Managed to get the boost to 0.97.

Afrs are 10.8/11.00 full chat which I am happy with.

goes bloody well,very noticeable difference from a stock ct9