scottieboi94 Posted November 10, 2014 Share Posted November 10, 2014 As above, how do i stop this happening and run the fan normally as it should run? Thanks. Quote Link to post Share on other sites
5e colin Posted November 10, 2014 Share Posted November 10, 2014 there is a switch on the piping to front off the rad to bulkhead you need to plug in the sensor back in and it will stop atleast i had to do it on my gt that way !!! Quote Link to post Share on other sites
davehart Posted November 10, 2014 Share Posted November 10, 2014 Or just bridge the connector if you have taken all the piping out. I did this with a paperclip and tapped it up. Quote Link to post Share on other sites
scottieboi94 Posted November 10, 2014 Author Share Posted November 10, 2014 Which connector is it? Quote Link to post Share on other sites
Stu Posted November 10, 2014 Share Posted November 10, 2014 Grey connector by the fusebox Quote Link to post Share on other sites
scottieboi94 Posted November 11, 2014 Author Share Posted November 11, 2014 Cheers mate, ill have a go at it in the minute Quote Link to post Share on other sites
scottieboi94 Posted November 11, 2014 Author Share Posted November 11, 2014 Cant seem to find the connector! I think there may have been a bit of confusion, i forgot to mention this only started happening when tuning developments put a gt engine in my glanza, they also removed some left over aircon piping which may have affected it also, someone mention something about a relay in the fusebox as well? Could that be a solution? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.