Paton Posted December 7, 2014 Share Posted December 7, 2014 Any tips or special tools needed to get the nuts that attach the cat to the turbo? Spoked nuts, don't seem to budge. Cheers in advance Quote Link to post Share on other sites
Paton Posted December 7, 2014 Author Share Posted December 7, 2014 Quote Link to post Share on other sites
Turbo Goose Posted December 7, 2014 Share Posted December 7, 2014 Doesnt a normal hex socket work? Quote Link to post Share on other sites
Paton Posted December 7, 2014 Author Share Posted December 7, 2014 Nah just slipped a couple of times on trying and I didn't want to start chewing at them. Quote Link to post Share on other sites
pockrockgtti Posted December 7, 2014 Share Posted December 7, 2014 Use a six point hex. Quote Link to post Share on other sites
Whitenoize Posted December 7, 2014 Share Posted December 7, 2014 (edited) I used a normal socket to take mine off today dude they don't even look to bad in terms of rust tbh seen a lot worse Edited December 7, 2014 by Whitenoize Quote Link to post Share on other sites
Paton Posted December 7, 2014 Author Share Posted December 7, 2014 Ok, cheers. I'll give it another go tomorrow. Sprayed it all with WD40 again so hopefully that helps. Quote Link to post Share on other sites
daniel_g Posted December 7, 2014 Share Posted December 7, 2014 Single hex socket should do it no bother Quote Link to post Share on other sites
Paton Posted December 8, 2014 Author Share Posted December 8, 2014 Got them off, now the bottom 2 nuts that are holding the CAT on a bracket are not budging. Getting there though. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.