FMuscle Posted December 27, 2014 Share Posted December 27, 2014 I'm dropping my engine in this week, wanted to know if there's a special procedure to follow for a 5E, oil pump priming or whatever... There hasn't been any oil in it since end of June.No, It doesn't have a turbo... Thanks Quote Link to post Share on other sites
morgey Posted December 27, 2014 Share Posted December 27, 2014 I just put an engine in thats not been ran for over a year, i just disconnected the kind lead and kept turning it over for a good 30secs-1min. My oil light went out in this time as well which is a good indication that its getting oil pressure.You could take the plugs out so the crank and rod bearings aren't under any compression load and it will make it easier for the starter. Quote Link to post Share on other sites
FMuscle Posted December 27, 2014 Author Share Posted December 27, 2014 I guess it would be a good idea not to run any fuel at that point... Easy enough, so once I get oil pressure on starter, just add fuel and fire to the mix. Sounds fun Quote Link to post Share on other sites
rwdrev Posted December 27, 2014 Share Posted December 27, 2014 pull the efi plug in the fuse box and disconnect the coil lead then whurr over till oil light goes out. thats how i do it. Quote Link to post Share on other sites
onnaj1000 Posted December 27, 2014 Share Posted December 27, 2014 Indeed remove the ecu fuse and then crank the engine. Otherwise when you'd only remove the coil cable or something like that a lot of unburned fuel can probably mix with the oil and you don't want that at a first startup. Quote Link to post Share on other sites
FMuscle Posted December 27, 2014 Author Share Posted December 27, 2014 Cheers guys. Can't wait to have this engine running... The 4E is out, I just have a few sensors to swap over and fit the pick up and sump when the 5E gets off the bench... Fit the flywheel clutch and trans when in the car... Quote Link to post Share on other sites
fiddlersport Posted December 27, 2014 Share Posted December 27, 2014 >https://www.youtube.com/watch?v=WsG_Mg0VDn8 Quote Link to post Share on other sites
FMuscle Posted January 2, 2015 Author Share Posted January 2, 2015 pump isn't priming... see here Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.