Jump to content

Recommended Posts

Recently bought wepr kit and a turbosmart wastegate now I'm led to believe that the wastegate has two springs in it, is it possible to remove one Spring so I can just run the 7 psi spring and get the mani and few bits on the car until I'm going to get it mapped? Also where does the second port on the wastegate have to be ran to with vacuum hose? First to a boost pressure source and second to where?

Link to post
Share on other sites

Some wastegates have smaller helper types springs inside the main spring, so remove it and see what boost it runs at.

Bottom port goes to compressor housing, top port just vents to atmosphere if your just running spring pressure.

Top port is used when your using a boost controller

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...