GlanzaCanada

Ok thank you for the help all!

An adjustable Panhard arm may be able to help with that toe in....check them out.

Put some new seats in, found a good deal on some Mazda RX-8 seats and bought them. Took a bit of work to make them fit, couple custom brackets, but overall they came out really well. They hold me much better now, and they are plenty comfortable!

Hey everyone, since we never had the starlet in Canada finding alignment specs for the chassis at an alignment shop are impossible. At the moment we went off a toyota tercel from the same year as my glanza v (1997) Does anyhow have alignment specs for the starlet/glanza? It's been about two weeks now and the car is pulling to right and feels a bit unpredictable at times.

messaged

changed the air filter location, decided I did need to drive the car a bit and maybe when it rains. I routed the intake where the coolant overflow bottle once was right in front of the battery, far safer and less dirty.

Ya they really do help the look of the car

Hey everyone, since we never had the starlet in Canada finding alignment specs for the chassis at an alignment shop are impossible. At the moment we went off a toyota tercel from the same year as my glanza v. Does anyhow have alignment specs for the starlet/glanza? Thanks

It's your thermostat I'm sure, when I drive on the hwy my temp gauge goes way down. Comes up to half in traffic but whenever I get going the temp drops. I replaced the rad cap because I thought it was that, but now I'm certain it's my thermo.

I'm pretty postive my radiator cap needs replacing, it's been steaming at the radiator cap and my car takes awhile to get to operating temps. Do the tercel and Paseo models share the same radiator and cap? Thanks!

Cleaned up

Custom Exhaust all done, put in the plug and play ECU as well. Getting an alignment done this week then Ill drive it around for a bit! Basically a straight pipe with a decat, but I added a resonator and tip at the end to give it a bit of a look. Crappy cell phone pics for now!

Anyone know the torque spec on the banjo bolt that goes into the front caliper from the brake line? 1997 glanza v Thanks a bunch!

Ya ill likely change the setup, it was just something to do while I was bored

got around to doing the front rotors, pads, and a paint of the callipers this afternoon....I would of done the rears as well but I was stumped by the fact the rear discs are also incorporated with the hub. So instead of swapping out the old rear wheel bearings I am ordering some new ones entirely. Oh and I snapped a hardline on the LF brake line trying to get the stock brake line off to replace with the HEL braided lines I got....just my damn luck! Looks like I need to get a line with a fitting now FACKKKK.

Ok thanks guys!

Where is the ring located? Is it the gear like ring on the backside of disc?

Haha...I'm just wondering what the integral difference is between a abs rear disc and a non abs rear disc.

Hey guys, so I placed a big order for the my 1997 glanza v, and when I ordered all my slotted and grooved rotors through id-workz I seemed to of made a mistake with the rear disc. To my surprise the car didn't have ABS like I thought, and now since I searched it the ABS box also isn't in the engine bay either...should of checked that before ordering. Anyways can I still use these ABS rear disc's even though I don't have ABS now. Or what do I need to take off or add to make the disc work? Appreciate any help!

Epic as it gets for the moment ;)

THANKS!

Installed BC racing coil overs quickly the other day! The drop has really helped the look and stance, the fronts can go down about another inch, the rears have about 2 inches to play with still. This was how they were setup from the factory, and to be honest it looks pretty good. The fronts I think are good where they are, the rears I will bring down another half inch or so.

yes they are brand spanking new thanks!

Hey guys, just received my new BR type BC racing coils for my Glanza V! Anyone know if these need to be preloaded per installation...or are they ready to go out of the box? thanks!

Ordered the IDwerkz front and rear brake package kit, and a set of BC racing coils last week! Plus grabbed a used Decat off a member on here