Idrees

I also got myself a CT9B. I was gonna go for a Hybrid but I think I'll be fine with this for now! With the actuator fitted..

Just noticed the manifold is cracked in more than 3 places I just hope I can get it repaired properly.

I'm a drug dealer hahaha!

Thanks Dean. I'm a full time college student doing my A levels mate

I'd heat them up when removing to make sure they don't break dude. I managed to break mine and refuse to pay £68 to Toyota for new ones!

It will take less than a minute from a garage dude, they'll just whip off the top nuts using the power rachet thingy!

Yo Love, I hope you don't use Fairy liquid to wash your Glanza!

A few more parts.. SPS Mild Steel Manifold Japspeed De-cat CAP Paddle Clutch SARD Rising Rate Fuel Pressure Regulator with gauge NGK Iridium Spark Plugs Glanza Rear Axle Glanza ECU Autogauge Gauges Boost, Oil Pressure, Air Fuel Ratio and Voltage. I'm ordering the oil and water temperature gauges soon. I think that's about it for now. I really need an engine crane now so I can get the engine lifted up and start work on it!

Poor cat!!

College til 4 Work at 5:30 til 3am Exciting. ;)

Thank you. I bought them and they are awesome! ;)

Coilovers, boost gauge, HKS actuator, a full service with Iridium plugs and performance HT leads and some other performance mods. You can get loads for £800 if you know where to look. ;)

Intersting stuff, I didn't know that! I knew they were nippy but not the Vtec thing!! Thanks for the info!

Thanks Johnny. Dean I raised it after taking them pics ;)

Thanks guys. Hopefully I'll have an update tomorrow.

Looking good ;)

Since when does the SOHC have a Vtec kick to it?! ;) Looks nice dude, liking the orange rims! I don't see the point of the heatwrap on the inlet though, it'll probably help keep it warmer therefore your car slower!

Nice progress ;)

The 4EFE one doesn't fit 4EFTE so I'm guessing it wouldn't work.

Very nice I have a soft spot for them especially after test driving one!

Congrats dude! Woooo Friday the 13th!!

I think the wheels look really nice, they suit it.

That looks sweet!!

I also see that your so JDM that you can't even spell Japan! Just kidding!

Looking good Chris, your ARB looks a bit too high from the back though. I think it needs to be flat but I'm not too sure if its necessary! I see you also got a Razo nob in the end then! I look forward to more progress!! Ps - Where did you get the sandwich plate from and how much? PM me