Jump to content

Central locking/alarm


Recommended Posts

if you dont have any electrics in the doors its a nightmare, as you have to take the doors off and drill holes in them, if you do have electrics in the door, then its not so hard.

Link to post
Share on other sites

Well if you went to a scrappers

You would need to make it dead easy:

Drivers and Passenger door looms(with clips!!), central locking servo, operating arm & last but not least the fuse and carrier for the central locking which is tuck up in the dash near the steering wheel!!!. Don't forget to make a mental note of what the connector looks like for the fuse carrier and write down the colour of the wires!!

It will basically be plug and play!!

strip your doors, install the door looms from inside the car out to the door.

Plug the door looms into the correct connector on the dash loom(Which by the way is a standard loom on the EP91)

fit the servos and operating arms then plug them in.

Finally find the connector in the dash (tucked up behind the steering wheel) for the fuse carrier, plug it in and screw onto the dash support bar.

I think thats about it!!!

Then give it a try.

I'm not an expert, all this information is from my own experiences and what I've seen from my own EP91. So I hope this helps.

Nath ;)

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...