bajansuperman Posted May 8, 2014 Share Posted May 8, 2014 would a bad map sensor cause these problem, hard starting (taking a while too start) , over fueling, low vacuum,low idle, staling and misfireing at high rpms Quote Link to post Share on other sites
Beastmode panda Posted May 8, 2014 Share Posted May 8, 2014 Yes yes yes yes yes and yes. Quote Link to post Share on other sites
bajansuperman Posted May 8, 2014 Author Share Posted May 8, 2014 thanks Quote Link to post Share on other sites
gorganl2000 Posted May 8, 2014 Share Posted May 8, 2014 ah, a fellow bajanlast time i had a bad map sensor, the car refused to boost properly, would start missing/hesitating as soon as boost came on did you try a diagnostic? code 34 i think it was you can also check tps, knock sensor, o2 sensor Quote Link to post Share on other sites
bajansuperman Posted May 8, 2014 Author Share Posted May 8, 2014 (edited) think it was 31 and 35 some where in that range would have to take a look again and o2 senso4 removed usein wide band Edited May 8, 2014 by bajansuperman Quote Link to post Share on other sites
gorganl2000 Posted May 9, 2014 Share Posted May 9, 2014 are you using the stock ecu?---removing the stock o2 sensor will cause the stock ecu to run rich http://www.toyotagtturbo.com/forums/showthread.php?2641-fault-code-31-amp-34 yeah, check your map sensor and both the electrical and vacuum hose connection to itmaybe try a friend's map sensor and see if it cures the problem Quote Link to post Share on other sites
bajansuperman Posted May 9, 2014 Author Share Posted May 9, 2014 most of what is being said in that link is happening plus the car's not starting and i'm running a bigger turbo so running a little rich is a plus for me till in get the money to put in my management..........also i having the same chatter he's getting but from the compressor houseing would the same map sensor problem cause this Quote Link to post Share on other sites
gorganl2000 Posted May 9, 2014 Share Posted May 9, 2014 chatter normally associated with not using a BOV or using Mesh or a short intake to turbo i'd strongly recommend you check the Map sensor and Tps settingplug back in the o2 sensor if you have it disconnected, as the car will run like crap without it-----same goes for the knock sensor Quote Link to post Share on other sites
bajansuperman Posted May 10, 2014 Author Share Posted May 10, 2014 ok fix couple thing but still not starting and gettin code 51 Quote Link to post Share on other sites
mikey4410 Posted May 10, 2014 Share Posted May 10, 2014 Just so u are aware dude a map sensor failing is seriously rare.almost never happens,plus ure code error isnt map I know that.of he top of me head maywell be a tps issue Quote Link to post Share on other sites
brendonware Posted May 18, 2014 Share Posted May 18, 2014 I have error code 31 which is making it not start, but its fine once its started "right" as sometimes it starts giving me a really rough idle and smelling really rich! no idea what to do! lol Brendon Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.