fordie_glanzaV Posted June 28, 2014 Share Posted June 28, 2014 (edited) anyone identify this pump. No markings on it. as i thought walbro have markings on them. Also i uncovered some crispy tape to find this. What connectors would people suggest to rejoin these as bit concerened it being around fuel. Any help will b much appriciated Edited June 28, 2014 by fordie_glanzaV Quote Link to post Share on other sites
JamesD89 Posted June 28, 2014 Share Posted June 28, 2014 That looks like a TD pump mate I used butt type connectors. Quote Link to post Share on other sites
fordie_glanzaV Posted June 28, 2014 Author Share Posted June 28, 2014 I did think bout soldering and heat shrinks... Just very spectical as it being around fuel.. Quote Link to post Share on other sites
akyakapotter Posted June 28, 2014 Share Posted June 28, 2014 I used solder and tape tape has probly gone by now lol Quote Link to post Share on other sites
fordie_glanzaV Posted June 28, 2014 Author Share Posted June 28, 2014 I havent removed the standard pump yet so im not really clued up on how close the wires are to the fuel..All i know is that wiring is no good as it is.You think solder and heat shrinks b ok then? Quote Link to post Share on other sites
akyakapotter Posted June 28, 2014 Share Posted June 28, 2014 I'd say solder and heat shrink would be fine Quote Link to post Share on other sites
Jamie5414 Posted June 28, 2014 Share Posted June 28, 2014 Through crimps Quote Link to post Share on other sites
fordie_glanzaV Posted June 28, 2014 Author Share Posted June 28, 2014 Ok cheers lads... think ill go solder and shrinks.. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.