antheon2010

Do you please have ep82 interior trim RHS ? @Bean

I need also wiring harness

How much for the loom please ?

Hello Great process and attention to detail you have here I need some help as im after an ep82 engine loom if you could possible help . Thankyou

Is this available pls

Any help on loom please for a 4efte

Can anyone tell me who is this guy please

Yes you can run a boot if one is considering everyday use. Yes it can be used for added camber but one needs to unbolt it but as as for your doubt that it may not be locked up its machine out of T7 aluminium and have steel timeserts M26x1.5mm to take M20x1.5mm rosejoints. A lefthand / righthand thread would be adequate but in this situation its very limited.

Yes depending how low you go. Its for people who love more b roads and push it to the limit on tracks.

The lower control arm on a car must never be higher then parallel to the ground. On lowered eps the lca point sky high and as a result starlets do not corner but more over try to turn into a corner as the geometry is not in a good form. It depends on how low the car is. Im finalizing my design and taking various drops to maching various pin lengths. The ideal lca position is to be pointed downwards so it shall be parallel to th ground when the suspension dives such as at a stock height car.

It depends how much one will go low. The vertical shaft that goes into the knuckle instead of the lca balljoint can be replaced to different length. I do have machined longer ones for more lowered eps.

It depends how much one will go low. The vertical shaft that goes into the knuckle instead of the lca balljoint can be replaced to different length. I do have machined longer ones for more lowered eps.

Hello Being a sport racer myself i have developed my personal roll centre adjusters and caster plates to aid in the handling characteristics of the under rated toyota chassis. This is what i have came to develep.I can possibly help if any are interested. I also have developed caster adjustment plates. Cheers

Hi Im after a ct9 decat. Shout out to a blitz .. Thanks

I machined my own. They do effect 100%

Update 😎

Rhd japan

Proper steel pipes dont shear. Water pipes which are seam welded DO SHEAR

Bucket seat rails left and right

How much for just the calipers please ?

Wanted 4efte ep82 engine loom

Ep82 cage. Please post what you have. Non sunroof. No rear seat friendly. No fancy prices. Thanks