Idrees

Yo Love, I hope you don't use Fairy liquid to wash your Glanza!

A few more parts.. SPS Mild Steel Manifold Japspeed De-cat CAP Paddle Clutch SARD Rising Rate Fuel Pressure Regulator with gauge NGK Iridium Spark Plugs Glanza Rear Axle Glanza ECU Autogauge Gauges Boost, Oil Pressure, Air Fuel Ratio and Voltage. I'm ordering the oil and water temperature gauges soon. I think that's about it for now. I really need an engine crane now so I can get the engine lifted up and start work on it!

Poor cat!!

College til 4 Work at 5:30 til 3am Exciting. ;)

Thank you. I bought them and they are awesome! ;)

Coilovers, boost gauge, HKS actuator, a full service with Iridium plugs and performance HT leads and some other performance mods. You can get loads for £800 if you know where to look. ;)

Intersting stuff, I didn't know that! I knew they were nippy but not the Vtec thing!! Thanks for the info!

Thanks Johnny. Dean I raised it after taking them pics ;)

Thanks guys. Hopefully I'll have an update tomorrow.

Looking good ;)

Since when does the SOHC have a Vtec kick to it?! ;) Looks nice dude, liking the orange rims! I don't see the point of the heatwrap on the inlet though, it'll probably help keep it warmer therefore your car slower!

Nice progress ;)

The 4EFE one doesn't fit 4EFTE so I'm guessing it wouldn't work.

Very nice I have a soft spot for them especially after test driving one!

Congrats dude! Woooo Friday the 13th!!

I think the wheels look really nice, they suit it.

That looks sweet!!

I also see that your so JDM that you can't even spell Japan! Just kidding!

Looking good Chris, your ARB looks a bit too high from the back though. I think it needs to be flat but I'm not too sure if its necessary! I see you also got a Razo nob in the end then! I look forward to more progress!! Ps - Where did you get the sandwich plate from and how much? PM me

WOW!! I didn't have any idea about this build! That is awesome dude you got some real nice goodies there! Good luck with it!

Nope not the lowest setting, still had about an inch to go. 195/50/15 Goodyear Eagle F1s, these tyres have quite wide walls too. More pics.. Gutted that I had to raise it only about 15mm though I think so its still pretty low!

I see potential! Good luck!

Sparky PM me if you still got the fenders for sale dude. I'm gonna raise it about 1cm today and see how it goes. I'll try to roll the arches out tomorrow too!

I noticed. I've gone a bit too extreme with the front so I'm gonna have to raise it. I took the arch liners out but it the wheels keep hitting the wings now.

Hahahha!