Jump to content

Starbuck

Club Member
 View Profile  See their activity

  • Content Count

    5882

  • Joined

  • Last visited

 Content Type 

Everything posted by Starbuck

  1. Starbuck
    full lock. It doesn;t do it when in a straight line or slight curved reverse
  2. Starbuck
    I measured the rear one (not the bumper mounted one) and mine was 7cm Height (stretched a little). So i'm sure a 6cm would be fine. Keep it a little higher off the rear axle. Oval type as before.
  3. Starbuck
    Just noticed over the last week when reversing that im getting a judder/knocking noise. Which bushes would this point to and are they easy to do? cheers
  4. Starbuck
    Thats a shitter! At least they didn't get it away.
  5. Starbuck
    They were tight (which is good) and needed some gentle persuasion. But otherwise fine
  6. Starbuck
    ^^^^^ not what you want to hear. But yeah goggle dude. Get well soon.
  7. Starbuck
    Mid section exhaust rubber replaced with these: Current resto on Abaris bolsters:
  8. Starbuck
    Only got the 2 rubbers. Need to measure the rear one. I didn't realise there was 2 sizes when i ordered. Fitted mids today:
  9. Starbuck
    nice and clean!
  10. Starbuck
    Looks nice fella
  11. Starbuck
    Found it yeah, cheers. But it seems like all the other images. They always stop short of showing the actual end piece all fitted... and i've looked at 10 or so....LOL
  12. Starbuck
    Ahhhh... the annoyance of any night out. Specially when they turn the hand driers off and break the sink furthest away from them!!
  13. Starbuck
    So good he put it 3 times lol. Cheers guys. Just looking for images now.
  14. Starbuck
    Do you mean 2 bolts (per wishbone) then on each side of the car? Allowing the wishbone to drop enough to fit the bar in. Does it drop out easy then? and does the ARB not get in the way? Edit: Scrap that. Just one bolt and it fits over the original mount and chassis (not inside) and then screwed back in?? The bar came with no washers? Does it need them?
  15. Starbuck
    info today would be great
  16. Starbuck
    middle ones i bought: http://www.tm-developments.com/index.php?m...5gjc7odqecvn8n0
  17. Starbuck
    Got a lower brace to fit. Is there a guide around as i can;t find one? How much do i need to unbolt underneath the car to fit this? Thanks
  18. Starbuck
    Just fitted those 2 today.. solid!
  19. Starbuck
    lols
  20. Starbuck
    pretty sure its 2 in the middle either side of the hanger and 2 on the back box. TM Developments sell the middle ones not sure if they're ok for the rear
  21. Starbuck
    NIce bits and pieces
  22. Starbuck
    Looks great fella. Nice!
  23. Starbuck
    That stinks!! Have you contacted Killamats yet?
  24. Starbuck
    Some nice parts......look forward to the setup
  25. Starbuck
    If it had a sandwich plate it would have one wire to the sensor which would be screwed into the plate and another wire to an earth point. Then another wire to power the light, if the gauge is a lit one. Although you can get them mounted elsewhere on the engine block/ oil pipes etc... which you might have
×
×
  • Create New...