kingo228

nice one explains why it wasnt boosting thanks buddy

is this bad , will it put the car in limp mode or retard the ignition ?

TTT

http://www.youtube.com/watch?v=iRGEkUYmAk4&feature=context-cha

my engine warning light comes on one it revs above 2.5k rpm , would this be caused by the oil light being on? also the knock sensor isnt connected could this cause it to come on? Thanks Dave

^^^ Thanks

i have been through all the fuses , il go through them again and check all connections Thanks

nice one Thanks

all fusees are alright :/ whats the dome light ? Dave

^^ no power to head unit , no back lights on speedo , head light symbol does not come on but main bean one does ? Dave

what sort of oil pressure should i see? its a new pump , just was a baseline figure Thanks

right guys the oil sender has like a round plate on the end...... and my plug does not look like it will go on and doesn't .. my plug is just like a 1 pin plug? is there a extension loom or something Thanks

Right guys , finally sorted this happy happy !! Was a earth in the engine loom that had hidden it's self , that's why it sometimes tryed to start when it had made a contact ! Thank you lot for all the help really appreciate it feel like a right penis now !lol Thanks again Dave

tps has 12v to it :/ I've looked through all fuses all are okay. rev gauge doesn't move while cranking - should it? how can i test the coil and also the injectors should the engine warning light come on before cranking? the conversion its self i didnt do, but it 100% ran before it dropped a rod. Thanks dave

thanks guys , il give the grounds all a once over thanks a lot much appreciate

12v to the injectors - 10v to the coil/module king lead is okay all grounded good fuel pump does not seem to prime when u turn ignition ? no engine warning light when ignition is turned on only battery handbreak and oil any suggestions lads ? thanks

il be interested in drivers side ?

nice one guys , right the oil pressure light comes on now i made a new cable for it . if i unplug the ecu while the ignition is on then plug it back in. it then puts the engine warning light on . but the engine warning light dose not even flash when i turn the ignition normally. and ones it was on if i put the wipers to on ( even thow they dont work) it would go out also it seems like it had a little burst while cranking like it fired once after i unplugged the ecu and plugged it in again. humm this is getting stress full also the front wipers dont work :/ no fuses gone either

nope :/ how would i do this? thanks

i have no spark so last thing to try is coil so a nice cheap working one would be nice

sorted thanks

yup tried that, got a cable and earthed it to the chassis :/ thanks thow

no spark ? has fuel pressure coil knackered?