Jamie93DLZ Posted May 28, 2013 Share Posted May 28, 2013 Is there a certain way of removing the drive shafts? are just pull them out like any other car? any pins holding them in? Going to start pulling the 1.3 gearbox out for the 6 speed this week Quote Link to post Share on other sites
PaulStarletSR Posted May 28, 2013 Share Posted May 28, 2013 3 bolts behind the brake disc u have to remove 1st,push down and they bolts will pop out of the holes,then thatl let u pop the drive shaft out of the box! Quote Link to post Share on other sites
morgey Posted May 28, 2013 Share Posted May 28, 2013 And on the gearbox end, no just the normal ring on the driveshaft that you need to pop the shaft out with, sometimes a small lever bar does the trick Quote Link to post Share on other sites
daniel_g Posted May 28, 2013 Share Posted May 28, 2013 The green cups, box side, often get stuck in the box and can be tricky to remove on the deck. Quote Link to post Share on other sites
The_Notorious_C_A_T Posted May 28, 2013 Share Posted May 28, 2013 The snap ring in the box side usually needs a little encouragement, ps don't use a little claw hammer to do it ;-) lol Quote Link to post Share on other sites
mikey4410 Posted May 28, 2013 Share Posted May 28, 2013 i used cro bar to remove my driveshaft cups (green ones) they took 20 mins to get out even with alot of force .bastard things Quote Link to post Share on other sites
Banbury Glanza Posted May 28, 2013 Share Posted May 28, 2013 Yea they take a bit of persuasion to get out but just be patient with it lol Quote Link to post Share on other sites
Jamie93DLZ Posted May 28, 2013 Author Share Posted May 28, 2013 Cheers people will start to tackle it this week then since the car is of the road Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.