Browner Posted January 6, 2014 Share Posted January 6, 2014 Lads I'm looking for the following... I have an ep85 turbo conversion converted to RWD.http://m.youtube.com...h?v=azlL42nvdfQRecently I detected a slight knock in the bottom end, although the car is still driving. I have a very good engine here to replace it with that has excellent compression, Athena steel headgasket and ARP Headbolts. I was wondering does anyone supply a baffled sump that might help the spread of oil in the sump when the car is doing rings?Need one ASAP as want to get it back on the road!Regards,Conor. Quote Link to post Share on other sites
Socks Posted January 6, 2014 Share Posted January 6, 2014 Race-Tech & Dean@RWD can both offer this! Quote Link to post Share on other sites
akyakapotter Posted January 6, 2014 Share Posted January 6, 2014 Try dean at RW-Devlopments Quote Link to post Share on other sites
Browner Posted January 6, 2014 Author Share Posted January 6, 2014 Cheers boyos Quote Link to post Share on other sites
AdamB Posted January 6, 2014 Share Posted January 6, 2014 Drop Abbott a pm mate, he got his and Jamie's from Rob Bernard who built his engine. Quote Link to post Share on other sites
karl. Posted January 6, 2014 Share Posted January 6, 2014 Are you thinking about selling that car anytime soon Conor? Quote Link to post Share on other sites
Krissyb Posted January 6, 2014 Share Posted January 6, 2014 X2 for Abbott I'm getting Rob to make me one up. Quote Link to post Share on other sites
Jamie1st Posted January 6, 2014 Share Posted January 6, 2014 Dean @ RW Developments made mine for me, car has done about 8 track days since and been spot on.Best to give him a call on 07727 963770 as he's usually super busy. Quote Link to post Share on other sites
starletgt-shady Posted January 6, 2014 Share Posted January 6, 2014 Same here dean at Rw did mine just before I went to nurburgring last year Quote Link to post Share on other sites
yaristurbo Posted January 6, 2014 Share Posted January 6, 2014 is it a expensive job? Quote Link to post Share on other sites
Amjad Posted January 6, 2014 Share Posted January 6, 2014 As above, how much does it cost roughly? Quote Link to post Share on other sites
Azz Posted January 6, 2014 Share Posted January 6, 2014 Surely any decent welders could make you one its not a hard job Quote Link to post Share on other sites
Jamie_VF22 Posted January 6, 2014 Share Posted January 6, 2014 X2 for Abbott I'm getting Rob to make me one up. X3 abbott sorted me my one out drop him a PM Its in my build thread Quote Link to post Share on other sites
Liam_D Posted January 6, 2014 Share Posted January 6, 2014 As said, highly recommend dean @ Rw developments Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.