jordan walker Posted May 6, 2015 Share Posted May 6, 2015 Has anybody else had problems with the ball joint touching the disk on the wilwood 4 pot setups? It makes a horrible grinding noise when cornering hard and I don't have a clue what I can do about it other than grind the ball joint away abit but want to make sure there isn't an easy fix before I go grinding shit that I need? Quote Link to post Share on other sites
jordan walker Posted May 6, 2015 Author Share Posted May 6, 2015 Few pictures of how close the ball joint is to the disk and the mark its making :/ Quote Link to post Share on other sites
akyakapotter Posted May 6, 2015 Share Posted May 6, 2015 Wheel bearing not collapsed has it? Quote Link to post Share on other sites
Rob H@RCH Engineering Posted May 6, 2015 Share Posted May 6, 2015 It was a common problem with all the willwood kits, but not all ball joints are the same some clear some dont, but a rub with a grinder on the bit of the ball joint that fouls will cure it! Quote Link to post Share on other sites
jordan walker Posted May 6, 2015 Author Share Posted May 6, 2015 Wheel bearing not collapsed has it?I didn't think of that actually surely I would have noticed it though if it was that bad? Quote Link to post Share on other sites
jordan walker Posted May 6, 2015 Author Share Posted May 6, 2015 It was a common problem with all the willwood kits, but not all ball joints are the same some clear some dont, but a rub with a grinder on the bit of the ball joint that fouls will cure it!Yeah Thats what I was thinking about the old grinder trick I just wanted a bit of reassurance first haha bit shit how some of the kits didn't fit properly like isn't it I imagine somebody paid a pretty penny for them when they were new! Quote Link to post Share on other sites
WallaceGlanza Posted May 6, 2015 Share Posted May 6, 2015 It's non genuine ball joints that are the problem. Had to grind mine down too. Quote Link to post Share on other sites
Keri-WMS Posted May 6, 2015 Share Posted May 6, 2015 Just to point out the obvious, take REALLY easy when modifying the balljoint guys! I hate balljoints, they are always 1mm too close for some ideal disc I'd like to use on some random car's kit..... Quote Link to post Share on other sites
Glanza-Ben Posted May 6, 2015 Share Posted May 6, 2015 In the second picture it looks likes your wheel is rubbing aswell on something Quote Link to post Share on other sites
jordan walker Posted May 6, 2015 Author Share Posted May 6, 2015 Cheers guys and I'll have a look at that wheel aswell ben thanks dude Quote Link to post Share on other sites
Keri-WMS Posted May 6, 2015 Share Posted May 6, 2015 Well spotted, that's the caliper touching the wheel and milling a groove into the base of the spokes! When you get the wheel off make sure you check it out properly, and probably get someone to blend it smooth again - aluminium hates stress raisers and the base of the spokes isn't a good place to have one... Quote Link to post Share on other sites
Mad Mike EP82 Posted May 7, 2015 Share Posted May 7, 2015 As said non gen are the problem. You can run camber bolts to get more clearance. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.