5T4R7ET N/A's Sportif Turbo

[5T4R7ET N/A]

Been super busy recent so no updates until now.

Had to wait a little while but the next step is here. 

Going to still need some other bits to go with this as i want to run COP.  The list is getting a little longer but progress is being made.

[5T4R7ET N/A]

Looking for one of these for a while now. They were going for stupid money so i had to be patient. Finally got one.

80mm Greddy boost gauge. Its a mechanical one just to show you pressure. 

 

 

[Clinternational]

Nice build mate, Whats up with the swap from emanage to COP ? whats the diffrences between those ?

I know emanage is out of date :P

[5T4R7ET N/A]

Its been over 2 years since i have worked on the starlet. Cant believe it. 😱

But now thanks to prolozone treatment on my back I can do things now. Thank god!

I also bought another Toyota family car. Its got a 1JZ, 😊. anyone want to guess what it might be?

 Thats a another project which i hope to start doing more on after starlet is back on the road. That way i will have a car to drive if one is being worked on. 

Now the life storey is done I will start updating this build soon. Got loads of little bits recently 

[RoyalDutchie]

I guess it would be a Toyota mark 2 blit or a crown estate😉(I do prefer a 1jzgte crown estate myself).

 

It is nice to hear you still have your starlet, keen to see your further progress.

Edited June 17, 2020 by RoyalDutchie

[Zemerz]

Welcome back mate. I too have recently returned 😂😂

I'm gonna guess a mark 2 or crown aswell. 

[5T4R7ET N/A]

Yeah its a Silver crown saloon. Cant believe how smooth they are. My one is bone stock auto at the moment. Thats a another project to my list. 

1. starlet

2. crown (daily)

3. Mk1 Leon cupra R (wifes car)

They are all turbo petrol cars 😎
 

When i start working on crown probably put another build thread on here. 

I plan only to change wheels on exterior keep a nice plain look. Want to make a sleeper

 

[5T4R7ET N/A]

I needed a new intercooler as my old one had weathered pretty bad. The fins were turning in white aluminium powder plus i wanted to change the setup a little.

I measured up and this is the biggest i can fit with my setup. The hotside will remain very short and the cold side will be a little shorter inside the chassis leg as before. 
This is only 5mm thicker than previous intercooler so should fit ok. I hope 😅
 

back

front 

 

top

 

Will be mocking up soon to see if any mods will be needed to make it fit. I want to retain the crash bar. 

Edited June 23, 2020 by 5T4R7ET N/A