starletezy

Haha!

If you have just Installed the turbo it's always good to poor oil into the oil line and crank it over couple times

No problems mate

No that won't mater I'm running no filter my mates shaft was solid at the time aswell no oil leaks present eather

Mate had the same issue the turbo was dead check your actuator and vac line as check for shaft play

Pro sports electronic gauges are really good same as the depo gauges

Sounds like your thermostat might not be kicking mate

^

^

You most likely will have to fit 10mm spacers for them to fit mate

^

^

Don't know how people get away with normal paint. Heat paint is better as it heats up it gets even more solid like power coating.

So clean mate love it

Agreed 2k is abit dear for an second hand forged engine

Use VHT Heat paint mate will do the job

2k depends on the spec. If your forging your own engine you probably will spend 2k boarder line but buying and forging I don't know about 2k lol

Very true

Yes would be a good idea mate make sure you use an Oem gasket aswell

Nice build!

^

Dastek now SOLD

Replied

Have changed my cover gasket 3 times using OEM never had to use sealant once

EP91-EP82 GT 4EFTE ACL big end bearing standard size used in good condition (£12 posted) Tuning developments Half size rad bottom mounting bracket with bolts and washers brand new (£15 posted SOLD Tegiwa tow hook (£15 posted) Universal 10mm spacers 4x100 5x100 (£15posted) EP82 cooling panel brand new( £30 posted) ​SOLD Ep82 parcel shelf with speaker holes cut out £25 posted) ARP head bolts only coverd less than 50miles before being removed %100 re-useable there basicly still new £45 posted These cost me £130 an absolute bargain​ SOLD Located in East london