marki7

White glanza on Elton rd derby was in front of u in my blue scooby

Bump... any one got a good rolling shell I can just drop a engine in cheers guys and gals

On the hunt for another glanza wishing I never sold my last 2 I do have for swapz/sale a factory civic ek4 vti vtec. Contact: 07565309902

There glanza's always seem overpriced

It's not about hitting the rev limiter mate that's how you're engine is going to go bang again. Fuel cut kicks in when you're boosting over factory high boost so turn the boost down

Same again while it's off it would be silly not to. To me it's safe practice if u take something off with a seal on it replace it

No fcd. Do I need to swap out the map sensor or look at other things first. Cheers for the help lads

Ok getting 31 and 34. Read 31 is map sensor.And 34 turbo pressure. Are these right

Cheers for that link nick will give it a look tomorrow

Hey all..few symptoms with my v at the minute. Rough idle,try to rev it and it splutters,strong smell of fuel round inlet manifold/fuel rail only when u rev it,engine light is on,also all three boost lights are on. Checked for leaks in the whole bay air,fuel and water. Tried resetting the ecu still the same.checked plugs and leads. Thanks for any help guys and gals.

Daily weapon

Ok so my heaters only work on full. changed the resistor with brand new one from Toyota and still only works on full. what else do I need to look at or change. Help please

Mini(johncooper workz) drove one of these they are animals but spin up a lot till 3rd Polo(1.8t) drove my mates tuned one not a bad little car and cheap now BUT it's fooking german lol

Anybody got a pair of front fogs 96 spec need the bulb holders to as they have been copped off the loom. Cheers guys and girls

Got a thought in my mind already about a crazy engine swap into my glanza haha

Ok bit of a long shot but I pulled my heater control out my glanza today as nothing was working. Turns out there is nothing connected to the knobs does anyone have the cables or whatever it is that controls them.

Merry Christmas to all

As said get a compression test this will help to make your decision. At the end of the day it's your money and car if your wanting it done. make sure all gaskets and other bits are genuine Toyota or u will be doing it again

Nice... what's the spec list

So took my dash apart today to look why my heater blower only blows on the windshield and hot. and there is nothing attached to them 2 knobs. is there some sort of cable or rod that should be attached to them

Top seller parcel arrived in the blink of an eye. Thanks again mate. Merry Christmas

Pm me bud I will take these

is the gearknob weighted mate

Epic find.. would love to get my hands on some originals

Impreza wrx (blobeye) after my GT and Glanza but soon brought another Glanza for the fun factor love my scooby but things get serious when I go out in it lol