-
Content Count
31 -
Joined
-
Last visited
Content Type
Profiles
Forums
Wiki
Media Demo
Store
Calendar
Everything posted by TD04GT
-
Heat wrap length to cover BUDDYCLUB SPEC II??
TD04GT replied to zaffydoo's topic in Intake, Turbo & Exhaust
I wrapped my full buddyclub for my GT as well, bit of a pain as it's sleeved with springs and you can't really wrap round that lol. I think I bought 2 x 10m rolls but don't think I used it all either. -
Thanks for the advice lads. I think I'll send the hubs and discs along together to have them lathe'd and spigot rings made up then.
-
I've seen many posts saying you need spigot rings to centre the astra discs used on a levin twin pot setup, does anyone actually know the specs or sizes of the spigot rings? If I was to bore the inside face of the discs which fit over the hub to within 0.5mm of the diameter for a snug fit, would this make the spigot rings unnecessary?
-
Chancing my arm for a decent second hand one before I buy new as I'm in no rush. Will keep in mind thanks though.
-
After a v-band one if there's any out there for sale.
-
G6r gearbox here with bell housing swap done if you're interested.
-
Im after a healthy Blitz or Orc clutch with release bearing..May also consider os giken. Pm if you have one or could have one for sale soon, no immediate rush. Thanks
-
Bought a speedo convertor off Trev and it arrived within 2 days well packaged and with a free trd sticker
-
Still looking if anyone has one.
-
As title says, after the alloy mount. Rubber or poly bush.
-
I think your bang on there, the fact your blowing more air could cause a weak actuator to fail.
-
Relocated short route air filter and pipes for ct9 turbo
TD04GT replied to thomas cleeves's topic in Wanted
You can make them up for about twenty quid off ebay -
Pm me Bean you can't get any more messages. I've a g6r 6 speed box with the bell housing converted.
-
I've a 5e block for sale if you haven't one of those already
-
Another vote for wepr. Their work is second to none
-
On my gt with 15" wheels and stock rpm limit I get about 40 in first, 65 second, 90 third and fourth is off the clock so I don't know exactly - can't honestly remember if it hits speed cut before the limiter. It does get there very quick though.
-
There's a fujitsubo power getter on the Facebook selling sites for good money
-
Usually a difference of 15psi / 1bar between cylinders indicates a problem in that cylinder, your second test shows that in 1 & 4. Do a leak down test on it and see if it changes the results
-
Civic ones on ebay fitted my gt without modifying anything. Bolted straight up.
-
Newly rebuilt engine for sale on the Facebook selling pages
-
Distributor leaking onto thermostat housing
TD04GT replied to Flaminsam's topic in Ignition & Fueling
Have you a part number for the seal as mine is leaking out the dizzy now too