fiddlersport

Thank you dude

Any one have the pin outs for the 4efe ecu uk 98 2 plug ? thank you

pop off drive shafts and take a look through the hole, or shake the drive shafts to see if there is any play on the g-box side, sounds like the bearings on the diff possibley, seen it before

oem all the way because them aftermarket cheapish brands only last a few weeks and then the noise comes back

looks like its a trip to id for the flywheel............ close thread pls

I have a set of 15" 4x100 5 spoke 4 new tyres all same brand fitted 2 months ago £100 + delivery,

bullet proof engines they are !

pm sent your way

dam, looking for some seats and you are close but no rails, ashame

bump

they come in the evo 2/3 aswell

I would also like to know which other toyota seats go in to the ep91 with little modification, them recaro are expensive

Hi Anyone heard of Milano spoke alloys, they have made in japan on the back of them.

pmd

Hello engine vibration coming into car and culprit is the rear engine/gearbox mount, i grabbed the inlet manifold and rocked it back and forth and its fooked my car is the 98 uk 4efe ep91 will a glanza mount fit and is there any differences between the mounts, i know the lsd have different mount so i have read somewhere, correct me if i am wrong I have a 5e waiting to be dropped in so here is my chance to fix at the same time. should i go polybush ?

Hello all sorted, morgey was correct regarding the 2 wires need to be bridged, 2 bonus points to morgey lol

I can take it if you still have, i live locally to you matey

still available ?

pmd

Hello require the 5e flywheel which will allow me to use the 4e clutch to go on my 5e engine

try cleaning it, hot torch flame

pmd

Hi morgey will have to get the wiring diagram side by side and try figure it out before i strip anything

Hello folks can it be done ? basically i have a 5efhe engine which is going into my ep91 1.3 keeping it n/a for now (future turbo project maybe) i am pretty sure the the ecu in my car is the 3 plug since it is a ep91 the 5efhe loom is 2 plug and is a auto ecu do i use the full 5efhe loom and ecu or use the 4e ecu and what problems might i run into ? i know the exhaust will not fit due to the block is 10 mm longer and need modifying the 4e does not have aknock sensor i have been told what can be done ? thank you

so many glanzas breaking nowadays, sad to see a good one like this broke, hope the sale goes well matey