fiddlersport

Finance on coilys, WHEN ?

I just installed a set on a friend car and they are pretty decent

the bits for this car got sold faster then a piranha east a gold fish lol

nice build dude, good work

when is the next meet dudes ?

i have a set of them greens knocking about, what are they off if you dont mind saying ? thank you

updates ? very interesting

I was on the motorway on a long journey and when i came off the motorway engine was really smooth, the long run must have sorted it out

Hello thanks for the info, I will be fitting it soon so hopefully it will put a smile on my face when i put my foot down and notice a difference (hopefully) lol I have the full exhaust and mayjust install back to front if it fits, its of a toyota sera which had the 5efhe engine

Hello dont mind me asking but why are these £250 ? are they special or something ?

Hello when you replaced the oil filter did you put a small coat of fresh oil on the new oil filter seal (rubber) and hand tighten the filter ? jack the car up and clean it then start the car up while it is jacked up and inspect fro drips ! should be easy fix, hope this helps

Hello I have a 5efhe exhaust mani for the 4efe on my N/a starlet, the manifold is the 4-2-1 but it seems it may require a little modifying to make it fit, is it worth the hassle guys ? i still need to remove the cat but it seems to be attached all the way down from the downpipe, do i just chop it out and install straight-pipe ? Thank you

Hello I have the 1.3 4efe and i also have spare a gearbox from a glanza v, would it be worthwile swapping over ? straight fit or need flywheel,shafts ? Thank you

still intereste in a n/a 1.3 lump ?

interior still available, I have the dreaded 1980s grey interior, so old...

rear brace bar still available ?

Hello Guys Its all working now, only really needed to swap over a few wires, thanks for the help

Car is still on the original 13" steels and handling is really poor !

Hello Paypal good for payment ? I would collect as i am only 40 mins away but my car runs like shit at the moment lol any rear strut braces available ? alloys 14" ?

Hi Require a corolla manifold for the 4efe 1.3 starlet and glanza strut braces, just after the stock braces which come from the glanza v Thanks

standard mounts from day 1, dont see the need for polybushed mounts on a 1.3 N/A

Hello manifold is similar to the picture above but with out the idle screw, the idle control valve is below the throttle body, can it be cleaned out ?

Hi I can feel vibration on the steering wheel when my starlet at idle, seems engine is a bit shaky causing this, any solution would be nice ?

Hello I have the 1.3 N/A starlet and would like to know if i just change the springs from a ep91 glanza turbo will that stiffen the ride for better cornering ?

I have purchased the clocks and also kept the connector woth extra wire attached, just looking for the thread on how to fit ?