akyakapotter

Welcome to ukso enjoy your stay

Pool of oil on your drive way? Where are you leaving oil from?

I don't have a flexie have a decat pipe there instead as that's where my cast goes still scrapes on the floor lol

its easy to do it you have the tools. I soaked mine in wd40 for a good 3days before i even tried to rotate

looks stock to me the stock piping is a right pain in the ass to fit proper tight

picture of it might help us help you bud

Up plug your icv mine ticked alot unplugged and ticking stopped.

Hours you have dial up Internet or something lmao

That will be chatter nothing wrong with that I've had chatter for well over 2years now

I've not thought about wings to be honest may look into it

Thanks Lew think I'm going fit it and leave it black till next month

I will get one shorty but not for a while. first few laps I was bricking it lol as you can see in the video start taking corners faster by the end of the session. ok so test fit of the spoiler today it's not a genuine was sold to Ben as one not sure if it's one of iddys fit is spot on. not to worry though going to drill out a few holes to make it fit like a genuine one. going to look mint when it's painted next month. Bottom pic is a genuine and what I'm going to do to mine.

Dosent the jam ecu not use stock fuel pressure?

Went and picked up a livesports spoiler off Ben yesterday last piece to my body work. roll on next month to get it resprayed and fitted going to look mean

Looking at that again looks like there is loads of codes looks like sensors ect just rip it all out will be cheaper in the long run

Looks like 72 and 34 to me

Just got back from bens he was covered in oil when I arrived flat out sorting stuff out again top service as always

So god dam annoying when your near it and it's on idle rattle rattle rattle lol

I did on track at combe and was fine

Mine feels much better with it disabled

Top picture is with it in bottom it's removed take that out and abs will flash

Give me 2 mins there is a pin that needs removing.

Need big ones little ones won't touch it and lots of wd40

Big circlip pliers and pliers to pull the locating pins out don't need to grind them off.

Less off that Mr slow