-
Posts
9802 -
Joined
-
Last visited
Content Type
Profiles
Forums
Wiki
Media Demo
Events
Everything posted by akyakapotter
-
hey all need this info asap as in the middle of doing it (again) used cheap gasket dose any one have the torque setting for the exhaust manifold nuts or even better a sheet with all the torque setting on it would be a great help as i don't want it blowing again thanks in advance
-
looked on camskills it was £18.95
-
Might have been caught speeding :( ARGH
akyakapotter replied to Matt1878's topic in Lifestyle General
it doesn't matter what way the cam is mate i got done with it facing me just asked me to confirm it was me driving id say they get your number plate -
Might have been caught speeding :( ARGH
akyakapotter replied to Matt1878's topic in Lifestyle General
they got me from proper far way all depends how he had it set up you may be lucky apparently 3 points means nothing as sooooo many people have them hope you saved your ass do as i did bye a snooper lol -
this is the tune you want :-D
-
lol you sure that wasnt turbo elbow one cat / decat one ? still £16 for one gasket wtf best work this time lol
-
mine is doing the same boost up to 3500 then nothing i think its due to my exhaust mani gasket blowing though well i hope it is hope you get this sorted
-
was surprised when i went there today to inquire about a block to mani gasket got it for £16.22 all in cheaper than off getting it offline and i get it this afternoon winner
-
Might have been caught speeding :( ARGH
akyakapotter replied to Matt1878's topic in Lifestyle General
depending on how fast you were going depends on what you get got i got done doing 44mhp in a 30 go £60 and 3 points not good :-( -
thats the fuse marked it in a red box mate
-
id say those two wires in your pic would be for the fuse i have on mine not 100 % though id say that earth ring will go to a bold under the plastic next to your right foot then its off the the unit at the back of the car in the parcel shelf
-
ill go out and try get a better pic of the what looks like fuse for you give me 10mins
-
here you go mate here is the wireing of my working one few pics looks like its a fuse in the pic below then looks like it taps into the little fuse box inside the car the black wire with a splitter on it then goes right through the car drivers side to the unit hope this helps you out a little mate
-
i have one in mine i will try have a look at the wiring for you at some point
-
tell me about it the thing that makes me laugh is when they try to get a vin number but its in jap they dont like that get well assey with you i dont think its ever going change though we are always going to get picked on
-
fair play to your mate its the same over here you get the people like us who spend alot of time and money on our cars and drive sensabial and then you get the idiots who drive round like cocks gives every one a bad name so the police pic on us all im sure if some one over here done that we would end up getting picked on even more till they found summing to fine you for lol
-
well here she is she started with blitz nurspec r cat back exhaust blitz turbo timer jam fcc jam actuator and racing hart alloys had a few problems with her over boosting when i picked her up got sent down to plymouth to be put on a rolling road to find out what she was doing it was over boosting this is the out come dyno read out. they ended up putting a bung in to stop her boosting so much temp fix next on the list was a decat and mani havent got a pic of the mani yet though the next thing was to fit my front mount next on the list is to lower her coil overs me thinks want it this low was with a full car going to work at a festival have a Sard RRFPR to fit when i get the adapter for the fuel rail
-
dose anybody no how to ajust this as i think mine is set a little to low been told you have to take the front off and there is a white screw type thing just dunno which way i got to turn it anybody shed any light on it as its letting me hit fuel cut i think error code 34
-
Fuel pressure Regualtor/Fuel Pump Overfueling
akyakapotter replied to madmax_926's topic in Ignition & Fueling
there you go bud straight from japland http://www.rhdjapan.com/sard-adjustable-fu...type-an-6-56396 will also need the fuel rail adapter :-D -
just fitted mine i love the sound of it and it looks cool to if i was you id defo do it
-
haha yeah mate get some pics for the hottest girlfriend thread ;-)
-
sure will mate lets see how much stuff i can confiscate over two nights lol
-
off up there tonight to do security work should be fun dealing with knifes drugs fires and all sorts i love my job :-D
-
I'm not sure has haven't looked at these yet maybe they have brake pad wear indercators maybe up pads are low
-
Don't think so mate but I would as it will be well bright when your driving at night bit like a sat nav not in night mode will do your head in lol
