Jump to content

td04 turbo

Member
  • Content Count

    165
  • Joined

  • Last visited

Everything posted by td04 turbo

  1. Could be an air lock did u bleed the system when u changed the rad?
  2. Intercooler pipe work any longer being a top mount?
  3. The calipers are the same the carrier brings the caliper further out to fit bigger disc
  4. Any one recommend a good diy kit for removing/ refitting of front wheel bearings thanks
  5. Interior carpet good condition? How much posted?
  6. My powder coater informed me that the plastic piece in side The fuel tank (some sort of baffle for fuel pump ?) Could be a problem when it goes in the oven any one else had this or will it be fine ? Thanks
  7. My powder coater informes me that the plastic bit in the fuel tank (some sort of baffle for fuel pump?) Could be a problem when it goes in the oven any one else had this or will it be fine
  8. Any one know how to remove the track rod arm from steering rack
  9. Try the basics first changing raidaitor cap if no joy try replacing thermostat flush system fill with fresh water/coolent make sure there's no air in the system also
  10. should not smoke at all on idel when warm ,Does it smoke when warm whilst driving/ boosting? Frm what your saying dont think so, if it smokes on idel when warm I'd say early signes of head gasket but as its not that bad when your boosting u cnt see it, possible signes of water getting in
  11. If its white smokes on start up & then lessens when engine is warm its condensation, but if white smoke is not present when u start the car, but gets worse as the engine warms up I'd say head gasket
  12. Have one here with Decat had very little use brought for my build not sure if I wanna use it now Have one here with Decat had very little use brought for my build not sure if I wanna use it now Have one here with Decat had very little use brought for my build not sure if I wanna use it now
  13. any look finding one yet?
  14. Zisco mild steel external gated ram horn mani & Decat what's it worth
  15. Yea a lot of them didnt have a press so I took it to a bk street garage who did 60 it cost thought that was a bit steep prob just me lol
  16. How much would labour cost on removal of 2 wheel bearings & pressing 2 new ones in with hubs all ready removed
  17. Uni flow fuel vent valve off a bike eBay just to be safe
×
×
  • Create New...