Ollieh17

Could get them for a couple of quid locally if i know they fit

As above? Need one replacement cable and there is a few 7afe celicas at a scrappy near me

Interested to see how the DIY oil feed gets on, would like to try one myself

Most probably something to do with the the turbo being twin scroll mate. Racetech not what they are on about. The car is nice and clean but depends what you want from a car. You could buy a cheaper glanza and build it up yourself for cheaper. This turbo kit is a bit ott in my opinion to run on a standard engine. Do a bit of reading around and research before picking a glanza mate. My biggest regret. If you dont know much about the cars wait till you do before you buy one

I need one that does home visits haha

Ive read online about packing the oil pump with vaseline to create a seal while its drawing oil as it wasnt primed. If oil down the filter hole doesnt work then ill try vaseline. No luck ill have to start taking sump etc back off

Good stuff mate, i need a 'ben' local to me to help me out haha. Need to get some new hose on them fittings though!

Yeh sump and pick up off

I meant cusco flywheel

Found the issue, cusco clutch and spec 6 combination meant the clutch rubbed on the bellhousing. Had to grind some of the clutch and bellhousing back

Yup did that, gonna try spin the pump manually on a drill

Taken plugs out to crank it faster but still dont think its quick enough

Yup remember fitting the o ring. Bought one seperatley from ID workz as was u sure what was what in the gasket kit. I doubt its the pump, i know it could be but doesnt seem likely. Is there a way to prime the oil pump?

Glanza pump

Will check that. Cant undo the pulley now lol

Its a brand new pump

Taken the pipe off and seems to be fine. Took the bolt out the filter housing too and its dry?

Cranking the engine over for the first time in a while. Not getting oil to turbo for some reason? Nothing coming from feed or return

Good stuff, thatcan replace the lambda then

Ryan laird had one i think?

Be careful though i managed to round the threads in the housing putting it in

Theres a m16 bolt in the thermostat housing, you'll see it it sticks out bit. Take that out and put one of these in eith a temp sensor in the middle

Super bargain this was!

Had another go turning it over after a bit of wd40 down the bore. While doing this i had a listen to the gearbox flywheel end and diffently some sort of rubbing noise coming from that area. Which is a relief i guess

Very nice glanza that. Pretty sure its mapped on a emanage blue. Fair price though, could get a forged one for close to that price