Jump to content

A L 3 X

Member
  • Posts

    1886
  • Joined

  • Last visited

Everything posted by A L 3 X

  1. I think it was just before i let off but might have been easing off?
  2. Can't remember your username, but spotted you today, I was at the side of you at the roundabout in Notts, was heading toward the m1 but you took the exit after mine, i would of beeped at you but I was in the work van lol, like the bronze wheels by the way...
  3. Ive noticed that when i proper boot the car at full boost WOT sometimes the car lets out a hellish pop/backfire(I assume a flame...) now I'm not sure if its due to it running richer as ive just fitted a JAM ecu and turned it up to 1 bar, or if its actually an issue? The car dont seem to lose power but im not sure as since turning the boost up it usually just spins through second lol Any ideas if this pop is normal for a richer setup?
  4. Eh lol? N yeah Steve that's my thinking, that's just as long as they don't cause any harm like that
  5. Ah I see mate, the thing is as its working I don't wanna mess with it and risk Causing a problem as I'm a bit unsure how to tell what suits the engine lol?
  6. The gap on mine is about 0.8mm maybe slightly less? they're ngk iridiums from iddy? So would I be best to ensure they're at about 0.9 or leave them?
  7. Ah right so should I widen them to say 0.9 or 1mm to be safe?
  8. Ah right, well it seems to run ok now, but how do you know if it blows out the spark?
  9. Ah I see mate, how come they aren't gapped like this from factory?
  10. Ill get a picture next time I'm N not 100% mate but Im sure i Installed it all correctly?
  11. Should I be widening the gap then? What does that achieve?
  12. It's a greddy profec a mate, it worked before but spiked so took it off, just put it on and now it won't go above .6 bar :/ N I bought the wastegate second hand the lad had it a few months, and it's a genuine tial mate
  13. Mike, They are all tight mate but ever since I fitted the external it's been like that, it's not like it even spikes it just peaks at 0.4 :/ And tris, I can't use the Ebc mate it Won't seem to learn, spikes and now won't even boost how I set it :/
  14. Currently I have a 0.6 bar spring in my wastegate; although when running spring pressure it seems to peak at 0.4) but I'm currently using a manual boost tee to run bar and I notice my screamer starts to come in earlier than 1 bar, yet when using my Ebc the screamer opens at almost peak boost and sounds better, but I'm not using the Ebc as it won't learn properly. My question is if I run a 1 bar spring will this open the wastegate at near enough a bar or will it still come in at lower boost? Cheers
  15. Deans work always looks quality.... Im glad you finally got what you wanted....although, enjoy the blowing off boost :/
  16. Ah, I think I got the first ones mate, is that ok?
  17. I was gonna say, checked mine and they are deffo below 1.1mm
  18. Nice one now I can drive without worrying lol Cheers
  19. Are they? Just fitted some but thought I'd check before driving?
×
×
  • Create New...