zebedee

Sounds good mate

1. Measure the total width of the wheel 2. Divide that figure by 2 lets call this answer A 3. Lay a straight edge across the back of the wheel then measure from this to the mounting face of the wheel (where it bolts against the car) lest call this answer B 4. B - A = offset Hope this helps it's easier without any tyres any more questions please ask.

http://youtu.be/n_qCd6Lx7pE

not sure but like i say cheap engough to buy and try seening as people seem to ask 30+ for starlet ones

Not 100% sure this will fit buy it's cheap enough to try http://www.ebay.co.uk/itm/200794297465?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

You must be rich because i nearly fell over when i got a quote from them, think i'll stick to heat wrap even if i do have to replace it every once in a while!

I've got a pair of sun visors:

Good to see you have got some money back buddy

yes they didn't come as standard with them in

About time people had to have 100 posts, or a member for 6 months before being able to post in the for sale section, reply to a wanted thread and send pm's to anyone but mods i think this would help.

EP91 or 82?

Depends on how it's designed if it's designed to flow oil to the cooler then back in if you block those fittings off with a plug or a sender then you will restrict the oil flow or stop it completly.

Yeah i found the feel much better i'm on 4 pot willwoods. Bleeding them took a bit of time i ended riging up a pressure bleeder

Yeah it is Shaun, the rear lines to the bias valve in the bay are fine but all the other had lines are different. Your braided hoses will be a straight fit.

I did have a pic but can't find it i'm sure Sicaln has a copy of it to mate had all the part numbers on.

I've done it wasn't too bad to do, it's easier to do if you take the inlet manifold out the way. I got my parts off Sicaln, you need the front lines, bias valve and the joiners in the bay as they are different.

Dealer can always ask more than private because they will deal with a part exchance and offer a warranty and finance.

bump

Bump

Abs can be removed too if you want i've done this and find pedal feel much beeter

Don't know how rare these are but might help someone out: http://ord.yahoo.co....tion/v246059213

If your not running massive power i'd go for i 195/45/16 which will give a bit of a stretched look over an 8J rim but not stupid.

EP91 or 82 buddy? How low do you want to go? Stock front wings?

What tyres are on them? The wheels should fit at that but tyre choice could make the difference

Looks ace with that bonnet mate can remember Dave B always wanting one What might look good would be a bulge to fit where the OEM scoop goes to make it like a Gi bonnet one for Iddy to get moulded up i think.