melon

Thanks guys Wasn't sure if the silicone would withstand it for long

Not gona be able to order a new bit because its on a bend, unless i cut through another section and join it in there. Will a section of hose last a few weeks? Not got enough money for this right now! Grrr!

I tested mine and it was fine, then went a couple of weeks later. I took mine for a quick 'test' with a good whack of boost and sure enough.... steamy! Seems this has happened to a lot of people

Santa kindly bought me a new front mount this year Its abso crap! The piping is too short to complete a full circuit by about two inches: Sorry about the rubbish picture, wasnt feeling rolling around in the mud to get a better one Old piping wont fit because this is about 2 inch diameter. Company that its from are playing gayboys are being unhelpful! Can I get away with a longer piece of connecting hose, or do I need to fab up another section? A million other things wrong with it that I'm gona have to sort, but at least if its long enough to complete a circuit I can

Mine did this and chucked the expansion cap off when I had my foot down then the head went two weeks later

Least it saves on fuel XD

Has anyone seen any decent deflectors on the net for at 82? Need to replace mine that got broken

Got me last year on the slip road dayumm!

Leeds Just braving the accidents on the m62 would take some confidence! Ha

How many ponies you got in your car? Lolol XD

Gona have to have a drive across to Hull and see if I spot you! Sounds brill!

I've done two sets of indicators. Best bet is to strip them down and put them in the oven- less than 10 mins at low temp- 30-50 degrees. I recommend you sit right next to the oven to watch them When they start to feel soft you can gently start easing the lense off. Be VERY careful doing this because the glue is some strong shit and you'll crack the lense if you try force it. If theyre not ready, put them back in the oven. Once the lense is off obv pull out the orange and then scrape all the glue out- this takes agesssss, but you wont get a good seal on them again if you dont get

PM'd

Ha thanks!

As for the passenger side you're allowed to use a soft strap plug. I've used the one from the centre seat in the rear Needs to be a proper one for the driver though

Let me know if you dont like it, got a 34 for sale

Forged 4e running 1.3-1.4. No figures sorry dude... literally bolted it on for a run up the drive a few times before a map then my ecu spat its dummy out and plans changed

my 30 was laggy but good fun give me a shout if you still need parts...

Anyone?

So I spent an hour last week finally trying to put a cambelt cover on the car... What size are the chuffing bolts that hold it on?! Even the old rusty bits and pieces on the garage floor are always too long/short

1) Tyrone Devine 2) Matt1878 3) Samantha1878 4) Bluebear 5) Melon

This is just for the intercooler? No piping?

Mine does it too, get new seals or pull the plug out the space saver hole and shoot off

Dogbox- waheyyyyyy! Ha. Best quote I've had for one making was a tidy £5k!

May as well join the girl post I had this problem last year (although not to the point of the car stalling) after I rebuilt the engine. Number of things you could check I guess- Check your lambda sensors is okay- unlikely but always worth a look because it might be reading wrong Check if your ignition timing is right, it might be out and so will idle too low- this was my problem Check the actual ignition wiring- if its the original loom then toyota did a crap job of the wiring and i've noticed age means its loose/breaking on a lot of GTs Check air valves, they might need cleaning out (get b