Jamie5414
-
Posts
1566 -
Joined
-
Last visited
Content Type
Profiles
Forums
Wiki
Media Demo
Events
Everything posted by Jamie5414
-
Bar the plates looks nice mate (Put the front plate where it should be!!!!!!) Once exhaust is sitting in the gap then it will look spot on
-
That's what you'd expect for a bigger, heavier & powerful (more potential) car.... How long is a piece of string, if it's well looked after then it won't cost anything apart from fuel and usual bits to keep it tip top
-
did you get a printout? post it up then you can probably get a place on the leader board
-
Powder Coat will look better and last longer IMO, as it is a thicker coat, but it will cost slightly more
-
flywheel and clutch torque settings ?
Jamie5414 replied to philfrost432's topic in Drivetrain & Transmission
Flywheel 90nM Clutch - > Flywheel 19nM -
ss
-
Bump
-
sold sold
-
ss
-
sold sold
-
Welcome to UKSO Best to post up pictures when you get it. That would help with gauging price a lot.
-
Oil light staying on/flickering
Jamie5414 replied to dan106's topic in N/A E-Series Engine Discussions
Does seem oil pickup is getting blocked, might be worth swapping it out or cleaning (at same time clean out sump and install magnetic sump plug) or if you use engine flush give that a go, a few people on here don't advise using it though, it could just make the problem worse by dragging all the shit around your engine. -
Replied
-
Bump
-
Bump
-
ss
-
How long ago did you have the tyres fitted have the weights come off from inside your alloys?
-
xxr522
-
Bump
-
fuel pump identification and wiring question
Jamie5414 replied to fordie_glanzaV's topic in Ignition & Fueling
Through crimps -
Shorter center rubbers mate, it will twist it and give 10-15mm gap, heatwrapping it too will stop it if you still get banging going over bumps
-
32mm nice and tight
-
Nice and smart buddy, clean too
-
sold sold
-
delete