Broony

Yeah what he said sorry i didnt explain as well as i should of. Basically tqake both hoses off that go to the heaer matrix on the bulk head put your hose pipe on one and put some rages near the other to help clear the water, turn hose on and loads of gunk will come out. and to bleed the car let it get up to temp with the rad cap off and fans on full inside. Keep squeezing the pipes until no air bubble come out. Take it work a short drive to shake any air around the system, let it cool down, take the rad cap off start it up again and check for air bubble and top up as required.

Cool project, so you guys will have 3 car between you lol?? Sell me you optional 3 point strut brace

try bleeding the system. I fixed mine by putting a hose on the bulk head and flushing the shite out from the heater matrix, blows red hot now:) as for your temp gauge make sure the connection for the spade terminal on the thermostat housing is clean if all lese fails try the thermostat. Rad fan run it around then once warm leave it standing for 10-15 mins you should hear the fan kick in.

Indeed for the price you can pick up proper rim!! it would be rude not too!!

Second that dont put Rotas on!! ^^^

Aye a know the feeling of time lol! im in need of a place that can weld ally to get my rocker done and intercooler pipe for my hks dump valve. Am sure you'll have it done in no time.

Yeah it does!! Aye av told him to get a blog up like! Whats happening with your at the min?

Cheers mate!! Yeah Fettled marcs last night so hes now running 1 bar solid Gutted i missed out on the big breakfast:(

Bump will swap for Glanza parts

Take indicators out Unclip wiring Undo 10mm nut Undo top clip and wiggle it until its free, be careful as they are brittle. Undo bottom clip and wiggle free by pulling up wards just check the clips are clear and that you not going to break them.

I just did buy its not there no more??

Cheers mate,ive got some angle iron to make some up just didnt know if they had the be a particular size .

bump for this some one must have a spare 5 mins to do some measurements??

Looks so good on those wheels!!

Howw much did they rape you for??

Cheers fella, My Bride holds better though:( if i couild of found anouther bride for the passenger for reasonable money i would of kept it but i was sick of having front seat that didnt match .

i'll be there if i can get Leave if not i should be there for saturday and sunday

Either bite the bullet and pay £100 notes from RHD or make your own I made my own for the 200sx and gonna do the same for the recaros as i have a Bride rail for the drivers just need to fab up a passenger

I really dont understand why people run mesh?? Itsd clear the the way to a furked turbo! but each to their own!!

Hahahahahhahahahaha!!! Glass Jaw

Im after the dimentions of the L brackets that bolt the the chasis leg as ive bought a RARB and they didnt come witht he L brackets so im going to make some up. Measurements of the actual size and the diameter of the holes Please:)

buy my Bride!!

Your Mental for not running a filter 80 I just used a normal 90 elbow that fits and then straight ally pipe to get it to the grill and then a hose to fit the pipe and then increase sizes to the hks filter

New Recaro fitted, just need to make a rail for the passenger. The most scary part of fitting this was modding the Bride rail as the Recaros have a low under carrage, but its all sorted and welded up:)

just keep forcing it, esculate it with paypal let them decide