davehart

Pretty easy to put on these. Are you running the stock top mount or have an aftermarket FMIC? The topmount, you have to removed the stock re-circulating valve, block up the hole in the EFI pipe (50p coin will do) and place a breather filter on the rocker cover or install a catch can. For the BOV inlet use the line that the stock valve goes into on the inlet manifold. Job done.

The question must be raised...why in gods earth is anyone listening to that shite?

That's just a normal starlet with the rear windows painted red....probably to hide all the random bits in the boot!

Looking very well John

They've lost one or two of my parcels in the past two. Bloody annoying and makes you look like a tit! Hopefully they can sort it out for you.

Try Daz at DWR Performance in Hasland. Used to work at Noble for years and I'm sure will have mapped a Starlet or two in his time.

They do sell new Toyota ones on Camskill. :: http://www.camskill.co.uk/m19b0s1296p14126/TOYOTA_OE_GENUINE_PARTS_-_Chromed_Rocker_Cover_Nuts_and_Rubber_Washers_EP82_and_EP91_Starlet_Turbo Bit pricey like.

I'm not a fan of Livesports kits but that does look rather nice! Shitter about the oil seals, is it still on stock CT9?

I'll be down for a day or two for this. Just need to get time booked off work. It's only a light drive from me. Not sure which car I'll be in though.

270 for an oil seal? I'd shop around Garages. I'd find out what seal it is that needs replacing. Engine side or gearbox side?

Threads like these can only be set up for those looking to expand there wanking material! Sparky....you have done us proud! Tissues at the ready boys!

That's quite funny...but why the bloody hell is it all over Facebook! I've seen nothing but pr0n all over it today.

If you've got no running issues then I'd bank on your heater matrix either being broke up just blocked up. Mine's freezing cold in the GT but I've never been bothered to flush the matrix out to see if its blocked up. Temp gauge pulsing up and down would indicate a buggered thermostat. Easy job to replace and cheap enough to buy.

Good luck claiming back from the council, even if you have compiled a whole folder full of evidence to go with your claim. They just don't want to know.

I think it looks gash to be honest. Ricer rear end.

That's all good and well but this just shits all over it! ::

Very easy they just pull off. The old one may be brittle so be careful not to drop any bits down the hole.

That looked pretty bad They should stick to watching TV on it!

What underground car park was this? Bloody wankers.

What a bunch of wankers. I'd post a shit through their letterbox and have em about it when they get back.

Take the door card and bits off then have a look but I'd bet its the window motor. If your as lucky as me, it will more than likely fail when you've just put the window down ,20 miles from home, petrol light on and pissing down with rain

May well be the window motor on its last legs. I've replaced a few on mine and its always been the motor fail not the regulator.

Drop S44 6BJ into google maps. It's just off J29a on the way into Bolsover. Would be good to have a fellow GT owner there.

Cheers Rob.

Where is this meet? Might pop up in the EP, it could do with a run out.