_shaun_

U can increase the boost above the wastegate spring pressure but can't lower it with an ebc. The nc port should be tapped into the manifold or other vacuum port and the com one leads out to the top of the wastegate turbo nipple to bottom port of wastegate

Sold

^

^

^

I've got a set in the house can measure them when I get home and let you no what size they are

Ha mines hardwired in already or I woulda

I'll take the rear anti roll bar if you can get me a pic Cheers shaun

^

^

^

Ha I was just being sarcastic

Guess you would have checked already but all the fuses ok? If they are then its a possibly race-tech have wired them all up to socks car to give him more power than you

Far to messy taking the sump off with all that oil. How about poping a spark plug out and replacing it with a long threaded bolt that pushes the piston to bottom dead center

I dream about my car probably abit to much. I once had a dream about blowing up my turbo on the rollers and when I woke up I actually started pricing up a new turbo before it clicked it was a dream.

That's a bargain to be honest

Pikey as fuck but the car didn't have brakes plumbed in at the time. Bang a bar between the wheels an the brake caliper/shock and leave it in gear. Get a breaker car and a ban a scaffold pole over the end of that aswell ha

Turbosmart advised me to contact one of there uk dealers I've messaged some but they have either not replyed or said they just sell the wastegates

On the rollers we couldn't get the car to boost past 1.2 bar no matter what we done. Mapper suspects its due to a Dodgey wastegate spring. Its a brand new turbosmart wastegate but I can't seem to find any springs for them for sale. Large spring is 47mm in diameter and am looking for a 1.2 bar spring. Any help lads? I tryed messaging eBay sells to see if they would measure there spring sizes but they didn't see. To bothered. Cheers shaun

Rolled arches stretch some 195s over them and don't go stupid low and ull be fine. Erik fitted his with surprisingly very little work and his was super low. If your got. Back seats don't bothered trying. Mine Just scrub with a an adult passanger. And an empty rear end

I run a set from the first batch and they run fine. If a little noisy but il put that down to the shims. Were the first batch not fine and the. He sourced a cheaper manufacturer for the 2nd batch that went horribly wrong

Aye I was thinking about it the other day probably the only gt I would have over a ep91. Just looks so slutty

No updates make me sad

Just remove the thermostat And try it like that will let you no what's going on. Its only 2 bolts and 5min job

What's happening with this now?